Видео

May be they are fused or something. Use a multimeter and switch it to continuity mode and touch the terminals of the LED if the LED lights up it means it's fine BUT if the buzzer of multimeter beeps means the LED is fused that's why it's completing the circuit. Then take a soldering iron and sort of melt the LED once you see its terminals use Solder wire and short them so the circuit gets completed. This is because all LEDs are connected in Series. I hope this helps

Solder the wires on the board. The board already has the marking on it to make the connection

@AayZeeHacks i just checked my light, the wires are perfectly fine and it still doesn't work

Try changing the USB cable and then try. Usually the cable gets stretched from the inside and wires break

@@AayZeeHacks how do I change it?

Then how were you able to see it?

Only if it's not working for you

It's probably an issue with the battery as it dies if not used or charged for a long time or even if gets overcharged. My suggestion would be to replace it with a new one. There won't be any issue with the software

Online from Amazon or any other store

It will definitely work if you clean the bit thoroughly. There will be no point to repair it if you'll purchase a new bit anyway

You're welcome

I can consider it in my future videos. Thanks for the feedback

Just peirce the first layer to make sure the air is released then it'll be safe

It's not if you do it carefully. Make sure to peirce the first layer only

It may not work since the condition of the battery is not same for everyone. You might need to replace it

If your watch is not turned ON since a long time, the battery starts to drain on it's own and eventually dies.

This is something that shouldn't not happen but even if this is the case I would advise you to apply some solder flux on it. Also make sure that the bit you're using is originally a solder bit and not any other metal rod.

Go to a repair shop for replacement

I used to use the exact method as you said but in this video the tip is rusted. Therefore, I used sand paper first. Once it's cleaned we can do the same process as u said. Thanks for the advice 🙂

really

I have the same problem😔

It's very simple first you need to take your memory card and save your audio in the MP3 format then try the process. I have made a video in which I showed how you can listen to audio in DZ09 check that out on my channel. Thanks

@@AayZeeHacks Ok😊 ill check it out, thank you very much!

@@AayZeeHacks hello again, sorry to bother you but it still doesn't work :< I followed exactly what you did but still did not work

I think there's an issue with the memory card because MP3 is the most common audio format. Here's what you can try. Connect your memory card with the computer then format it with either FAT32 or exFAT format try these two options and then save your mp3 audio and try to play, it should work. These two options depend on the compatibility of your memory card so u have to try both of the methods which works for u

It may not work for everyone

You're welcome 🙂

No, it won't, just try to do it carefully and it'll work.

There is the issue with the battery you have to replace it as you can see in my video that the battery starts to charge, although it was old, but the battery was functional. The possible reason is that your watch was off for a long time which caused the battery to die and therefore it's now useless. Once you use a new battery it will definitely work.🙂No worries

So i need to use new battery?

Yes

Yeah that's also a good method to do so thanks

I understand, if you want to replace the solder bit with the screw driver bit. It might not work as it has a coating on it but you can still try it. If the old bit is stuck so it might be because of the rust or something. You can use rust removers like WD-40 to loosen the bit and try to take it out.

@@AayZeeHacks ok. I,ll give it try