- Видео 17
- Просмотров 48 597
Charles Juedemann
Добавлен 29 авг 2010
Gloria mowing grass on her John Deer LX277
Just fun video of Gloria mowing grass on her John Deere mower. She does not like ZTR's and this mower has a pretty sharp turn radius so it works well for her. The JD LX277 is powerful, easy to operate, and virtually trouble free.
Просмотров: 177
Видео
Peelaway apple peeler and apple sauce
Просмотров 385 месяцев назад
How to use the Peelaway apple peeler and make apple sauce
Old Threshers Reunion Young Engineers Running Steam Engines at Mt Pleasant Iowa September 2022
Просмотров 5252 года назад
This was taken at the Old Threshers Reunion in Mt Pleasant Iowa on September 3rd, 2022. These are just two of the young men and ladies at the Reunion and just a sample of the many early steam traction engines. It is so fascinating and fun to watch, especially when the young participate. My favorite engine was the Case Killer (not shown) only because he made a lot of noise. You know, like loud t...
Rylan catfish fishing in Missouri
Просмотров 354 года назад
Rylan and Grandma catching a catfish in Poplar Bluff, Missouri, June 1, 2020
Rylan and grandma rollerskating 2-19-17
Просмотров 1127 лет назад
Rylan and grandma rollerskating 2-19-17
Ford 2000 tractor hydraulic line removal 1
Просмотров 9 тыс.9 лет назад
First video how to remove hydraulic line on Ford 2000 4 cyl gas tractor Next video is at ruclips.net/video/6p1CAJrT_DY/видео.html
Ford 2000 tractor hydraulic line removal 3
Просмотров 10 тыс.9 лет назад
Third video how to remove hydraulic line on Ford 2000 4 cyl gas tractor
Ford 2000 tractor hydraulic line removal 2
Просмотров 12 тыс.9 лет назад
Second video how to remove hydraulic line on Ford 2000 4 cyl gas tractor next video is at ruclips.net/video/KBFs0tlKPzk/видео.html
Farmall Super C rear outer bearing number
Просмотров 5539 лет назад
Farmall Super C rear outer bearing number
Excellent
Nice
When reinstalling the line what SEALs the back of the tube?
Well, this is a pretty late answer but the tube is stepped (not really tapered) and is pressed into each section so that as your tap it into place it is a press fit. I did use some bearing locker on each step area and it has been perfect for over three years now.
do you have one on replacing the PTO side pulley seal?
Where did you get the parts from ?
Sorry this is probably too late but I put the part numbers so that all you have to do is to take those numbers to the nearest bearing supplier or search on ebay.
excuse me the number of the bar or the tracer axis which is if you know the number could you tell me thank you for your attention
This is very helpful. I’m getting ready to do this job on my ‘48 C.
Da
For sale me