Видео

Dust caps can be cut out and replaced on most models worst comes to worst.

Nice.

Good vid about a great watch, love mine.

How did you remove the grills?

Hey cool video I have the same system which belts did you use I cant find any info on that?

Jake, after trying all the other techniques i seen on here that didnt work I tried the glue stick trick, I worked perfect the 1st time.Thx !!!

I'm thinking of getting an scr 22 it's pretty similar looking to this one

It is very difficult to find any info on cybernet audio

It’s been 5 years… Is it still holding up well? Just got mine last December, really enjoying it.

suction cup should work too

It's really funny that they actually get fooled. I do this all the time

I used my vacuum cleaner .it worked perfectly

Тake Karcher vacuum.

I didn't know about this technique. Thank you and have a good day my friend.

But what is your daily activity? Digging with bare hands?

Use vacuum cleaner

song in the intro?

Dude why'd you take the tags off the front grill? That's what makes these so cool!

I'm gonna figure out how to restore the orginal stuff as much as possible. The band may be a given but the some people would prefer to keep the orginal bezels and if one could figure out how to repair them and bring them back to spec...

If u would have used just a DAB of toothpaste with no water u would have got the results u wanted. If u ever watched someone buff a car look at the amount of product they use and how much surface it covers...it's the same thing with that crystal only scaled WAY down

Io faccio con il bidone aspiratutto

Try using a hair dryer now and shrink the composite of the cone.

Should have started with wet 2000 grit then polish

It works

👍

Vacum Cleaner ? ...just go delicate with suction and don't damage it more ...use some elastic cord/rubber tube between hard plastic and speaker.

0:52

Just use a piece of scotch tap. Lay the tape on the dent and pull it back up

Not so good for me...

just put your lips and inhale. much better and more efficient 😎

Súper...🧐👌

I'll try that

???

Thanks

Very pretty birds look it up we have a few that comes around from time to time

This was the only method that was able to somewhat fix my covers. They are fiber caps but if youre careful you can do it without any further damage. I used my big shop vac and they didn't even budge. I found using a hair dryer helped to soften the dome a bit and allowed the hot glue to come off easy after a few slow pulling attempts.

Нет товарного вида 🤣🤣🤣

vớ vẩn

To release the glue stick you need to twist it, not keep pulling it

Naked raygun?

try carefully using a vacuum cleaner works perfectly

This worked for me though it takes a the shiny layer of the cone and leaves it a bit rough.

did your watch have lug problem?

I've been pretty successful using a vacuum cleaner but just don't go crazy!!

1st of all...u can just buy the replacement glass. Another thing, wouldnt it be more easier if u take the bezel off before polishing it since u r gonna change it to a new one later on..?

Ja jsem měl stejný problém on stačí vysavač chapež

Brilliant!

Just use a vacuum cleaner to pull it out

You can also use a hoover with a sock over the end so it doesnt damage it

I use a small vacuum cleaner. Works everytime.