Видео

In my 2000 Chevrolet Impala it got me first gear and drive it goes slow to after you get out of first gear then go down the road fine how can I fix that

I have this 9055 code, but my alternator has been good for the 3+ years I’ve had the car. It is currently able to charge the way it’s supposed to. I have no indication that the alternator isn’t working. All I know is that my auxiliary battery is not charging, I get the 9055 code, and the convenience functions off and visit workshop messages. With the car off, trunk battery reads 12.6, AUX battery reads 12.6. With car running, trunk battery reads 14.2, AUX battery reads 12.6. I’m losing my mind over this.

You ever heard of code p062b ?

I agree with you, I think the radiator cap is not the right one. I have been researching this type of cars and I realized that they have another defect, this is that when you fill the antifreeze tank to the maximum it starts to overflow, so you should only put it to the minimum, and this way you will avoid it from overflowing, and you will not have any problem with your car overheating.

Damn

No this doesn't tell you nothin bout how to remove the head or anything, trying to show you what he did afterwords is a complete waste of my time .

What motor do u have

Engine immobilizer

So I actually own and run a mechanic shop. Just today I had a customer come in 2010 mkz 3.5L. P0351/355 and P0300. Cylinder 1 and 5 coils were melted like that- thought okay let’s replace them shit happens. Replace them and same thing almost immediately- started looking up tsbs and found where ford has an issue with this engine as there is no circuit fault protectant built in- minus the 15amp fuse to supply charge- back to the pcm. Essentially the coil shorts and it’s a 2 way street sending that circuit about 15-50k volts* idk what these produce* back through the line and frying the PCM. Ohmed the wires for continuity- no short to ground or power. Had to replace and program the pcm to fix repair. Also per ford TSB- you have to replace all coils and plugs and then the pcm or they don’t warranty it. Tight lines bro! -GoneFishingGarage

#autozone crap….

I had the same problem and found a chipmunk got up into air filter box and chewed 2 wires to the TCM , butt spliced them and transmission works fine.

An honest mechanic is what we need around here in N vA.

The main problem is that cheap asf shifter cable that gets stuck somewhere in the way back or forth thats what is burning transmissions since we dont pay attention to the weird sounds that makes because its driving just fine...nevertheless its wearing out the transmission faster than it should not shifting right into the right fork or gear letting it jump back and forth if it wants

Solid video…did you ever figure out the actual issue? I have a QX56 that randomly won’t start…then it is great for several weeks and randomly won’t start again.

Hello AK, I was wondering if the alternators you put in first charged for a while with normal voltage 14+ even with load like high beam, full ac, heated seats and so on and then stopped charging because terminal 61 would not talk back to the computer modules resulting in fault codes 9050,9051 and 9055 from BCM. Best regards

i like to see a mechanic, not a parts replacer...GOOD WORK BOSS! How you know the timing marks? I could not see where it lined up on block.

That’s the exact same marina we were at😅

Did you ever figure it out?

Well done 👍 Thanks for sharing. New Sub

I’ve got a ‘14 which was the first year of the redesign. Have had no tranny issues, and 210k miles so far. Best car I’ve ever owned.

Why can't they make a new transmission that will fit ? Just had mine rebuild and it failed again after 1 month. I have 3 year unlimited mileage so it was replaced again, they said the band snapped. I have the SS and the mechanic said they are not able to handle the 300 + hp and tq. So why can't they build one that's able to handle up to 400+ hp and tq ?

Thanks for the video. Your video is the only one I can find for 2013 newer nissan engine. One question about your camshaft lobe position when the engine is put back together and in time. Do the first pistons camshaft lobes point out or are they pointed down and out a little? Not sure if you remember since making this video, but you have them covered with the cloth and I can't tell. Thanks

Hi where are you located and how long does it take to install a new head gasket and starter for this vehicle? What should I expect for the repair cost?

I smell antifreeze . But no leak

What was the code it was throwing?

You still changing out trannys for impalas?

Does the 2014 Ls limited edition has the same problems?

Man you’re 100% right! The dealership is a scam majority of the time!

We don’t care what the last mechanic did .when you make videos please focus on the content at hand . Thanks for the location .this video could have been 2 mins 😑cut out all the extra talking you’ll get more views

AK, Great videos. I think I've got blown head gasket on a 2011 xj, and I would love to have you work on it. I'm in Dallas. Where are you located and how do I get in touch?

2008 chev impala

I have metal flakes in my transmission oil

I have a 2006 buick lacrosse 3.8l recently car overheats. When I opened radiator I see sludge all inside. I flushed the radiator real good and I put water in to diagnose before I use coolant and no thermostat. Everything is crystal clear. As its idling I can see an oily substance float up to the top of radiator. Oily substance in over fill tank. Oil dipstick shows good oil. Do you think head gasket is worn in an area that would cause oil to mix with coolant?

Where are you located?

I just replaced one and it might be a little too late for you but all you need to take off is the grill, there is no need to dismantle the whole front end.

Its the band in the transmission. There bad about breaking. Im building one right now. May make a video.

always pressure wash your engine to see things clear

Even my A4 B8 vibrates from 125km/h,whenever i make a full swing on reverse it feels like the left wheel brakes...I suspect it could be the cv joints.

no cap

A low quality chinese coil copy from amazon nuked itself? At least the tube seal is intact and didn't fill the sleeve with oil.

Do you have a shop or anything? I’m really interested in your work want to get some work done

Do you have a shop or anywhere you do work?? I’m a young black man starting my own trucking business and I’ve been getting ripped off a lot! I just want someone I know can trust, if you have any contact info please get back with me thanks in advance!

Get to the point next time.

Man I gotta have mine done. It looks like a btch to fo myself. Thanks for the upload.

Nice job! I have a jagure xf and it’s over heating so the Machanic tells me it might be a warped head gasket. I have to check to see if it really is.

Tramission ?

Omg that clicking in the god damn dash drives me nuts sometimes!

I agree with you. Nissan should take lessons from other manufacturers in design

Aluminum trailers are supposed to FLEX !!!!!!😂😂😂😂

Did this age well?