Видео

Nice, but would have been good to see how to replaec the cells. I pulled mine apart to that level, but then couldn't get the board off. Undoing the screws o nthe board didn't release it. So I couldn't test or replace individual cells.

You positive you didn't hook up to a Constant Power? I cant see how it could Draw from an Ignition Sauce when turned off!

I just installed my Kings 25A DC-DC charger and found the same problem. What did confuse me was that after the engine was switched off, the charger continued charging the Li-ion battery at 24amps. It took a while to stop. I was worried it would flatten the starter battery.

I got the same vacuum and it’s 15 years old and it’s not gone bye-bye

thanks so much bro !!

Thanks mate

Great explanation. Thank you so much for posting this informative video. Do you know where in the circuit the constant current, constant voltage logic is or how exactly it works?

should the lights go solid green when car is running? Mine constantly flash

Hello, I would like to buy the fan from that blower from you if you still have it/ are not doing anything with the parts, are you willing to sell? A few of my fan blades broke and Kobalt does not make a replacement. They no longer make this model and the new version is like $250.00 and are known to burn out their throttle trigger switches.

I have a suspect controller too. Cannot see a blown part, but mower runs eratic. Either runs on its own or a little on the trigger bar after left for a while and then goes back to running on its own.

Love your work Bob

Oh. Google said this was the RS version. Mines not a metal cover.

Ah the exact info I was looking for. Thanks a lot!

Not true vanon battery? true Vanon batteries use Samsung or lg batteries

36v 16ah battery which charger use sr?

But if it is not connected, will the solar panel charge the second battery or it will stay on standby mode. Because I feel like my solar panel is staying on standby all the time (and it is well connected

It will have balancing... It has to have it because without it, it would risk overcharging one or more cells. The balancing would be the simple type where it just applies a load to any cells that are at 4.2V before other cells. That's what the heatsink is for.

thankyou! i was about 30min away from trying to wire the blue wire into a cig plug for no reason.

I ride recreationally on exact same battery, Hailong brand. No issues, no heat on the sides, long range, hills, offroad👌

I found a controller that looks to be the same as this one. It comes with a motor and I found it on eBay

blue wire on dcdc chargers is for smart alternators if you don't have a smart alternator don't connect it.

It’s good for matches lol.

Hey I need help with some hall wires I don’t have any on my current motor and the one I’m getting has them what should I do can I run the motor without hall wires

Really helpful thanks

Goodday! What is the top speed?

Hey my friend I know it's been awhile since this video but if you still have any of that I would love to have it an see what I can do with it an thank you for the video 2966 slate creek Rd Grundy Virginia 24614 if you don't care to help me out I need something to do here I am in a nursing home so anything to pass off time an hope I am not being a bother but thanks again for the video

very well explained, thanks by the way do you know why a step wave ups is making like a sparking noise only when inductive loads are used with it?

Great video. I will do mine tomorrow. One question: my battery has two transit plugs on the new battery. One red and one black. Do I remove both? Thanks 👍🏻🙏

I've had two rad batteries, one since 2019, and that one got sold with my bike with 3800 Mi on it, in working condition. My current 48 volt rad battery that I'm using on my bike right now, has a documented 12k (!) Miles on it, with only a slight loss in range, after all these years. I ride my bike a minimum of 5 Mi a day, and I got to tell you other than being through three or four Chargers that burned out from getting caught in rain storms, this is one of the most reliable battery powered thing I've ever owned. It's absolutely amazing that the Samsung cell, ( greenish blue) along with a fairly large circuit board BMS, has managed to run trouble free for over12,000 mi, and still going strong. I am amazed by this performance. Thank you, Rad bikes for a fantastic product.❤Rad💥😏👍💯

Thanks, finally someone has shown a filter change in a 2013 Barina, I haven been searching for days

18650GA is Sanyo battery, 3450mAh and 10A, Colour is also correct :P but question is: is it oryginal Sanyo?

Great video!

I rekon its exactly how its intended to be used. All the tiny lathes are known to be a bit crap , the hobbiest bit refers to the hobby being the continuous battle to get the dam thing to work for a while. I made one from plywood ,it was not good but slightly better than that in my biast opinion. I applaud your efforts ! The square peg in a 3 jaw chuck is priceless.

I have an early revision of a Snapper 82V leaf blower. It has an infinite speed trigger. On max trigger it'll pull 1000W from the battery pack, and push my arm back. So, be careful. (I came here looking for a part number for the motor so I could look up a spec sheet.)

My battery is getting warm. It looks like this one 😢

'Promo sm'

If you slow down and practice they ain't bad for $160

Hey mate, did you end up havimg any luck repairing or modifying this unit to run for longer? Would be very interested to see how its done. (Baattery swap is easy enough but im very interested in how you'd modify it) Picked one up for really cheap of marketplace to keep my 3d printer going during small blackouts and I wanted to see why its not powering on when its not plugged in to 240v, beeps once and screen displays "650VA" then immediately powers down when you release the button. Will check my batteries and use this video as a guide. Cheers heaps it was very informative!

Im havjng issues with the on and off switch. Was wondering if thered any way to fix it. It wont turn on and constantly on.

I need just the fan blade part, I can't seem to find it

Cool to see the internals. A quality battery?

Lol when you cringe at yourself 🤣🤣🤣 you did a great job, thank you both from me and Nina 🫶🏽🫶🏽🫶🏽

Another shitbox badged as a Holden!! No wonder they are extinct pushing this shit on people.

More importantly, what did the Label say the battery was in terms of Amp Hours of current and voltage. Often the sellers of battery packs engage in liar's poker on specs.

Good

Nice video, my soft start unit failed so I've bypassed it. Everything seems ok, I was worried the start current might be too high but audibly it seems ok. Time will tell.

what did you end up doing with that blower motor? I made a homemade air conditioner with mine during the hurricane when we had power out I got bags of ice and put in the cooler and then use the motor to blow over the ice and blow out a hole but nonetheless just curious if you did anything with it or if it's just sitting around like mine is now my room looks like a junkyard with all the stuff I take apart and build things with

Bendiciones me puedes mandar la conexión de casa cable 🤗🇨🇺 soi de Cuba 🤗 Díos Bendiga

Thanks for doing this, I really wanted to know what they looked like inside/cell-counts... thanks.

Nice one dude