Видео

Yes, you can perform a full flow rate test on a Vent-Axia Advance Sentinel Kinetic ventilator for both extract and supply. To conduct this test, follow these general steps: Preparation: Ensure the ventilator is properly installed and all connections are secure. Verify that the unit is clean and any filters are in good condition. Equipment: Use an anemometer or airflow meter suitable for measuring the air volume and velocity. Test Setup: Access the control panel of the Sentinel Kinetic unit. Set the unit to maximum speed for both extract and supply modes. This may involve overriding normal operation settings. Measuring Extract Flow Rate: Measure the airflow at each extract point (vents) using the anemometer. Ensure the measurements are taken at the point where the airflow is most consistent. Record the airflow rates from all extract points. Measuring Supply Flow Rate: Measure the airflow at each supply point using the anemometer. Ensure the measurements are taken at the point where the airflow is most consistent. Record the airflow rates from all supply points. Calculation: Sum the recorded airflow rates to determine the total extract and supply flow rates. Verification: Compare the measured flow rates against the manufacturer's specifications to ensure the unit is performing correctly. Adjustment (if necessary): If the measured flow rates are outside the expected range, adjust the fan speeds or check for blockages and repeat the measurements. By following these steps, you can effectively test the full flow rate of both the extract and supply functions of the Vent-Axia Advance Sentinel Kinetic ventilator. If struggling, give ATSPACE a call to carry this out for you: T. 0345 6465 454 sales@atspaceltd.com

Hey, thanks for your comment. Yes, part F ventilation is super important, especially with all the houses becoming more airtight. ATSPACE will be happy to assist, welcome to speak to one of our relationship managers 0345 6465 454

Don't do it....

Thanks for your question, Jason. While I can't recommend a specific replacement for exhaust vents, I suggest caution with roof vents due to the efficiency issues I've encountered. I always try to aim for the exhaust to be designed so it comes through the wall. For wall vents, investing in higher-quality options is wise. Also, please ensure professional installation by a skilled tradesperson for the fan and ductwork. This can greatly improve performance and longevity. Prioritise quality over cost for reliable ventilation solutions. Sorry for being vague; I would love to have time to test all the different options. I suppose with more experience, I will have better knowledge in time to come.

@@atspaceltd654 Brilliant, thanks for getting back to me. Very helpful and much appreciated 👍

Thank you for your insightful comment! You're absolutely right that each construction method has its own set of advantages and challenges when it comes to minimising air leakages. Paying close attention to the finer details is crucial, as the devil truly lies there. Understanding the specific junctions and interfaces where air leakage is most likely to occur is key. While SIPs offer significant benefits, in our experience, we've found that focusing attention on wall junctions and roofs is essential for achieving optimal airtightness. These areas often require extra care and precision to ensure a robust seal against air infiltration. Nonetheless, SIPs do provide a solid foundation for airtight construction and can streamline the process, particularly when combined with meticulous attention to detail in critical areas.

Thank you, we're glad you enjoyed the video. Don't forget to keep your eye out for more videos on our channel and if there are any questions you want answering, let us know and we will see what we can do!

Thank you for your kind words about the tutorial. I'm glad you found it interesting. Unfortunately, we're unable to share the Excel sheet, sorry about that. However, we are here to help where we can and will continue to upload videos which you might find useful.

Hi cookers are tricky, best practice is to hold the hood over the exhaust outside of the building from the kitchen extractor, this will give you your flow rate.