- Видео 71
- Просмотров 186 213
Fuel up 727
Добавлен 21 дек 2017
Hemi spark tuning to add performance
Many people with chargers challengers and even rams complain about 2 things. the first is the slow rev or decel and the second is throttle response. this video will have go over these two things and how to fix them.
Просмотров: 1 725
Видео
Tuning the ram for long tube headers and cat delete
Просмотров 1,2 тыс.3 года назад
this is a 2014 ram 1500 this applies for dodge charger and challengers along with ram 2500. hope you guys enjoy the video and helped you guys out that are trying to tune on your own.
Dodge tuning 101
Просмотров 4,1 тыс.3 года назад
just going over the basic tables for the tune files on a 2014 dodge ram 1500. i hope you guys like the video and comment down below. i use hp tuners to do my tuning i also use this software on the 99 dodge ram. if you guys want a video on that let me know as well that on has a jtec computer.
Removing steering play on a dodge ram
Просмотров 3553 года назад
i miss spoke in the video. the allen size is 4.5mm lol but its super simply and you have to do little adjustments at a time so you dont do to much or you might get binding in the gearbox. I hope you guys like the content and comment down below if its helped or you have done this before.
Ram tach swap
Просмотров 323 года назад
make sure to stay close to the year your truck is. If you do a 95-97 it wont function correctly. the junkyard is the place to go for sure for these things, super cheap and most trucks still have them in there after years of people robbing parts of them.
1999 dodge ram blower motor fix
Просмотров 1,4 тыс.3 года назад
When this happens make sure to check the fuses first and if that checks out fine then move on to the motor and unplug the motor from the vehicle. hook the motor to a power source to see if it works, if it doesnt then replace the motor. If it does work then move onto the relay thats located right next to the blower motor under the glove box. Usually those have physical damage when they go out. s...
Dodge ram exhaust leak fix
Просмотров 6973 года назад
fixing the exhaust manifold and replacing the studs with bolts. its alot easier to use bolts instead of the studs because the nuts on the stud can back off and for replacing the manifold for headers it will be a lot simpler in the future.
1999 Dodge ram window replacement
Просмотров 3,1 тыс.3 года назад
i had a broken window in the new project. take off the door panel. it has 3 philips screws and take off the window crank and take it off. then theres 10mm bolts holding the window to the mechanism. and to put it in just slide the front of the window in first and work the back end in. just be very careful and dont brake the new window!! comment down below if you interested in tuning videos or co...
How to disassemble headlights
Просмотров 2083 года назад
put the assembly in the oven for 200F and for 10-15min and take out with a oven mitt and use a screw driver and a knife or pick to pry the lens off. be gentle because with the assembly being hot it will be brittle.
How to replace dodge ram starter
Просмотров 1513 года назад
very simple to doe for the two wheel drive trucks but the 4x4 guys you have to maneuver around the 4x4 bracket that is in the way of the lower starter bolt. use a swivel and you will be able to get to it. hope you guys enjoy and stay tuned for more videos the will be out once a week. all the crazy schedules are done lol
AEM afr gauge install
Просмотров 774 года назад
afr gauges are cool and all but can you install them lol well its pretty easy you can replace the rear o2 sensor and put it in the same location. or you can use the bung it comes with and weld a new location to have the afr sensor be put in.
How to adjust dirt bike carb
Просмотров 684 года назад
not to bad to do. if you dont have the aftermarket screw like i do, you can use a flat head screw driver and turn the stock screw for this adjustment. righty tighty is lean and lefty loosy would be rich.
How to fix suspension sag
Просмотров 1844 года назад
on a cheap budget? my 1990 camaro has a very saggy front suspension that is at least an inch or 2 lower than stock height. the part i used you can get from autozone or any parts store pretty much. just jack your car up and put it in you springs and there you go. helps for looks of stock and ground clearance that may have been lost over the years because of worn out and saggy suspension.
How to replace fuel injectors.
Просмотров 4284 года назад
The part number for the replacement injector is 193300545-3 it was very simple to replace i just took two allen bolts out of the fuel rail and pulled away from the throttle blades. slapped the new unit in and presto all fixed.
How to paint a car with rustoleum spray can
Просмотров 7204 года назад
its very easy to do and gets the job done when working on a cheap budget. just take your time and stay at least 6in away from the surface your painting so you dont get any runs in the paint. Also make sure to wait at least 10 to 15 minutes after each coat so you have a sticky coat to hold to the new coat your applying onto it.
Testing summit racing EFI at the drag strip
Просмотров 2 тыс.4 года назад
Testing summit racing EFI at the drag strip
Summit racing Max-efi500 install part one
Просмотров 10 тыс.4 года назад
Summit racing Max-efi500 install part one
Helped me out man!!! Thank you!!
Do you have an h-pipe or x-pipe?
Who tunes LT1 engine near Memphis
Doesn’t sound true duel to me
Thanks!
Could use some assistance tuning my gen 3 if your still active
Are you still active? Could use some assistance
Your too far away from the mic, I can barely here you.
Thank you. A lot of information? Do you have some advices using E85 as fuel?
Raytown?
I was told yesterday that true dual isnt possible on my 2014 5.7L ram😢
lol it forsure is bc I have the same year.
Thank you! I am hoping this fixes my issues! Also, do you know if it is possible to get a new heater core cover for this year, make, and model? Or is used the easiest way to go?
I just installed long tubes (sans cats) this past weekend. Gonna try your settings, as the initial info I had caused a "burn-your-eyes" rich condition until it went into closed loop. Gotta try to clean it up on cold start.
hey man jusy got a 2020 ram 1500 clasic and when going on highway trips would it be better to turn off eco mode and also all have to do it put in the highest gear setting to turn it off? and to get eco mode back just press plus?
How did you hook up the fog lights?
Sounds like shut
Awesome video, tried the settings on my 5.7 but I'm getting a little bit of surging when coming down to a stop
Is your car cammed
Hey man please redo this video. Please
I don't have a lot of high cammed engine experience but I would set idol between 800rpm and 850rpm. In my experience I think low idle sounds with high Cam.
sounds bad sorry
Can you redo this video please ! Great info. I would also like to know a little more in depth on tuning airflow. I read alot of info of people saying to cut the airflow numbers if you have a intake and larger throttle body , intake manifold etc... what differences will you see subtracting vs adding to the stock airflow table ? Wondering if im logging airflow correctly as well ? Tuning the factory cam for better performance would also be a good one !
Will work for high flow cats
What dodge tuning school or program did u sign up for?
A set of 416 heads, 1.5 roller rockers, Holley 600, high rise aluminum intake, and a summit k1103 camshaft and that 305 would run real good
hey so basically if i get hp tuners that comes with the adapter (sorry can’t remember the word lol) I can access the air/gas data? I bought performance injectors and coils, (comes with copy and paste data so i’m guessing in good to go after it’s pasted into the tuner? lmk guys
First speed bump…. By fuel pump
Are these a good system for 1996 6 cylinder.pick up ? I hate that “ Spider” carb now on it ( originally) that breaks often .
My car was tuned on the dyno and it looks like he focused more on WOT tables and not part throttle. Can I just copy from .35 and down on WOT timing and just past it into the part throttle from the .35 and down? Or does part throttle need to be lower on spark in last couple columns?
U never copy from wot to put on to part throttle u should scan your knock retard on the scanner with part throttle colum and row axis drive around scan add timing to areas that populate until u get knock
Better compare frist the differences and try to match via Excel. Don't to copy from WOT to part load tables, but look for a very smooth transition between WOT and PL.
Check out the 88 firebird formula 350 255 horsepower light weight and fast
Was there flange gaskets ?
The 93 front is just poor. The 92 and the Tran am bumper mo’ better
Would you say this works like a pedal commander? Like it down shifts without burying your foot? And it’s more touchy? Thanks
i have a 1988 v6 rs 5speed...just blew engine...idk what to do...shall i v6 or v8 or supercharge...im lost need help
Doesn't idle cause of your intake is a race intake
I just pulled my 3.8 out of my 2001 Firebird can confirm it was one piece and steel
What did you swap it to
What fuel pump did u run with this system
100% on you, you failed to properly use the tuner correctly. Diablo tune didn’t have anything to do with that
Can you send the base bin fil for the ram? I have the same exact year make and model too. Laramie 1500 Hemi
Currently trying to put a 97 pcm in my 96 regal. But not having any luck. Do you know what all had to be done to the pcm to make it compatible? Like pinouts and whatnot
GREAT KNOWLEDGE. MAY I ASK WHAT YOUR EXPERIENCES WITH TUNING VEHICLES? SCHOOLING, SELF TAUGHT? I HAVE A 2014 RAM 1500 SPORT CREW 4x4,8hp70,3.21 gear ratio. My mods are CAI 180 degree thermostat Long tube headers I'm installing now after I get these broken manifold bolts out. I might just leave them and try to get away with 6 bolts on drivers side and 7 on pass. Long tube headers are DNA motoring, cheap shit. NO CATS I have the diablosport tuner. DO YOU ONLY HAVE EXPERIENCE WITH HP TUNERS OR CAN ANY TUNER BE USED WITH CERTAIN SOFTWARE.?? I only run the 93 octane preloaded tune on the diablosport. From my understanding is you have to have a tune done to drive the vehicle with catless LT's. And the fan settings for the 180° thermostat.
dude might be really intelligent.....
Will this control when the electric fan kick on?
Yes
I enjoyed the video, I would have enjoyed it more if it was just about the window replacement.
Nice car man
How many cans did u use?
Your fault 100%. Tuner had nothing to do with you messing up.
Something wrong with ur setup brah. My bone stock 87 5.7tpi ran 14.50s all day long.
Yeah the dealer did the same thing to my 2015 wiped out everything
What gears are you running. The engine actually sounds strong. 2400 stall and 3.42 gears would probably really perk it up. Cool car!
Bro fuel pump at the bottom of the car 🚗 🤔🤔🤔🤔🤔🤔🤔🤔.