Видео

Can't get those controllers from ranco I don't have the number over the counter United Refrigeration try one

I agree with that I never had good luck with it that's why I switched

I use Ranco is the same as a Drexel will take his place recent cooler are freezer they have a good tech support Ashley's owned by I think Robert Shaw also can you use 18 gauge thermostat wire if the wires on the thermistors ain't long enough I used a couple they were fine

I don’t think female dogs are into peeing on fire hydrants 🤠

Nice video. I just subscribed. Happy New Year

I pretty much use dixells on everything. If you know how to wire them and go through the settings (which is very simple)

So why are the heaters not working? No way there’s 2-3 bad dixells in a row . All it does is send 115 hot leg out on terminal 7 , if you have 115 there then there’s another issue

When the evap.sensor is out,you can manually defrost it,by connecting line to the defrost line,and you can disconnect the compressor line,on the controller.you need to change FC from oy to on,so the fans turn off on defrost.d1 is room temp,d2 is evap temp,if it is no good it will not defrost.hope that helps.the controller they install was set for a cooler.

I would have pulled the bottom row of product then melted the ice with hot water and get them up and running. Dixells are super easy for the settings. Google search universal dixell manual and it pops right up

Ok good call I thought run Cap was Bad but your are right Safety First nice Video

Could be. Seems a little high in my experience. It’s usually around 180 PSIG bypass pressure.

Seems like most hoshis open at 180 and close at 225 on 404 , hard to tell when the remote’s data label is non legiable and neither is the valve data

Maybe the phases are wrong

Apparently I didn’t verify the sound settings on the recording software. I will redo this video soon.

Nice to me I watch the whole thing