Видео

decided to upgrade the fuel lines on my 67c10 5.3 swap to stainless steel braided hose with an6 fittings

This is part 2 of my 5.3 bogging down on acceleration so if you want to see what the truck was doing watch part 1. I asked for opinions on fixing this problem I got several comments saying plugs and wires, bad fuel pressure, dirty fuel filter, bad pressure regulator, bad injectors, mass airflow sensor, map sensor, dirty throttle body, so as you can see there was alot of possible causes for it t...

trying to figure out what is going on with my 5.3 swap and why its bogging down when I give it throttle. so I cleaned the throttle body which was dirty but sadly that did not fix the problem I have the new spark plugs to put on next. so let me know if you have experienced this or know what could cause this would really appreciate it thank you

decided to clean up the engine wiring harness had some leftover wiring loom. I was going for a cleaner look didn't want all the wires to show. I think its looking good so far if you like my videos subscribe and like so I can keep making more videos thank you

fixing my loose steering wheel on my 67c10 it has a tilt column I got off a 72 c10 but it slowly kept getting loose decided to finally take it apart to figure out what was the problem hopefully you like the video dont forget to subscribe thanks

fuel pump went bad had to replace it pump filter was dirty in this video you will see how easy it is to replace it thanks for watching

5.3 swap on a 1967 c10 how to wire the obd2 port to ls PCM

How to polish chrome bumper on a budget

I had a hard time trying to remove the shift seal so I ordered this removal and install kit on ebay for $21.99. This kit made removal of seal and installation of the new seal so much easier I got a couple more transmission leaks that I need to fix but I just wanted to show how I replaced my seal. Thank you for watching

Restoring door panel painting it and putting new door and window handles

Making a cover out of 22 gauge sheet metal to cover the ac assembly unit that goes thru the firewall. After I installed the ac system from the suburban I had a large hole in the firewall that I needed to cover so this was my 15 dollar fix I hope u like it and dont forget to subscribe so I can keep making more videos thank you

Replacing the battery tray on my 1967c10 I believe it's the same for years 1967 to 1972 C10

I took off the ac from the suburban and adapted it to the c10 most parts are from the suburban except some parts that I picked up at the junkyard. Hope you like the video

I was working on putting the steering wheel back on the truck and I noticed the truck had no horn and I decided to see if I could take a horn off the donor truck. Only one horn worked its sounds weird but it has a horn now

1967 c10 5.3 straight pipe exhaust

Replacing neutral safety switch on a c10

1967 c10 taillights wiring

1967 c10 moving ls computer inside cab

Installing lokar shift arm

c10 complete drum brake rebuild

5.3 ls c10 swap first start

c10 ls swap fuel system

1967 c10 ls swap

how to replace drum brakes on a c10

No brake fluid coming out of bleeder valve part 2

C10 gauge cluster

No brake fluid coming out of bleeder valve

Bleeding master cylinder c10