Видео

Hi Tom... it is set up, we just did not show it in the video. We have a separate video that shows all the app features at ruclips.net/video/St2UCgCQyjM/видео.html

Tom another smart tech product to investigate is the Moen Flo - some insurance companies are providing discounts for use of this particular product in your home. The Moen has an add-on product for the "smart sump pump monitor". While we have installed and like the Moen Flo... we do not have product experience with the add-on sump pump monitor.

Hi … check out Moens feedback on this … solutions.moen.com/Smart_Water_Security_Products/Help_Center/FAQ's/Is_the_Flo_Smart_Water_Monitor_and_Shutoff_compatible_with_a_hot_water_re-circulation_loop%3F “The Flo Smart Water Monitor and Shutoff is compatible with hot water re-circulation pumps. In the event automatic shut-off of the home’s water supply through the Flo Smart Water Monitor and Shutoff, it is recommended that the re-circulation pump is turned off to avoid any unnecessary wear to the re-circulation loop system. In addition, it is recommended that the power or pilot to the water heater or boiler also be shut off.”

This is the manual override instructions for water softeners… solutions.moen.com/Smart_Water_Security_Products/Help_Center/Flo_Smart_Water_Monitor_and_Shutoff/Manual_Override_for_Water_Softeners

assets.moen.com/shared/docs/product-specifications/spc15904sp.pdf

Hi Corb765, Thanks for pointing this out! Since this video was made we have made adjustments to this system and I did not update the video. On the first page of the instructions it does say to install the Moen Flo before whole house filters… · Must be installed after water meter, water shut-off, and pressure reducing valve (if applicable). a. The intent is for the device to monitor and control all the home’s water usage. The device should go before water heaters, water softeners, whole house filters, or irrigation lines if they are to be monitored by the system. However later in the directions there is a note for homes with a wells that does describe the mesh strainer you described. Please note: On well systems, install Flo after the well pressure tank with 100 mesh or finer wye strainer upstream of the device. I originally missed this note and installed it without the strainer. So again thanks for bringing this up. We had other challenges with this installation. The main challenge being it was before an irrigation system that was very large and was not consistent because it was weather controlled. Moen does have some work arounds for this but the owner wanted to by pass the irrigation system to prevent unnecessary alerts. During the re work we did do it down stream of a mesh filter.

Damn. So you watched the whole video just to say something negative? It’s always the ones who don't dare to produce their own content that have so much to say or at least you could have written it better.

So with all the adjustments that you made is it worth it? Have you had any issues with it or bad tech support? What are the parts to add to the line that you added after the initial installation? Thanks for the video. Liked and subscribed

Looking into this right now for a well system. I noticed this too. Moen says Flo needs a 100 mesh filter in front of it for well water.

We can definitely make that happen! Will share something within the next few weeks.

@@JustMaintenance thank you.

amzn.to/3YQuRS5

amzn.to/3k637tl

@@JustMaintenance thanks that requires an electrician. I wish there was something i could plug in with a backup battery that once it was forced to use battery an alarm would sound.

@@catapillargirl2021 check out the first product link... the ENDMAN Power Failure Alarm for Freezer Alarm, Power Outage Alarm,Power Loss Alarm with Rechargeable Battery (Included) .

@@JustMaintenance thank you! This other link wasn’t here before. Yay!

Not a necessity but nice to have … the insulated cover helps trap the heat lost from the hose bibb