Видео

And did you not see the part in your last video.. I put the time in the comments..

If I were you all, I would stop moving things, and see what effects the charges themselves have on your environment, preferably in a clear box, but I know that would be difficult to obtain. You could even use a cardboard box with plastic wrap on one side.. just something to stop motion and see what motion if any occurs. Would be pretty neat to see the smoke pushed away or attracted to. I think with my new design what I have built is the middle of the craft, and there should be a shell around it, it’s charge will determine these effects, it can be either positive or negative charged only, because the part I’ve built already IS the other charge and in doing so would complete the asymmetrical capacitor.. 👀

At 50v I am getting 10a to the zvs. In the video the guy had 65v an 16a. I thought I was over amping it. I have a 220v step up transformer from 110. I might put it in to reduce the amps and raise the voltage. First I think I need to make the frequency oscillate properly at low voltage. Basically I am missing the amplification point in the coil. I get 1 foot in distance. If I am right about the frequency. I could get the 3 additional feet without the step up transformer. I talk a lot about the amplification point in my video's. I should have realized it sooner. I also should have realized that a car battery wire should be used with proper connections for so many amps. I still don't understand how his wires were so thin and it did not get hot. Unless his amp meter did not work properly.

The vibration in the rope looks cool too.

Not sure what is really going on here😮

👍

What if you placed a bigger magnet on one side, like a 6-inch outside diameter neodymium magnet, and removed the magnets from the other side, like you had before concentrating the field more? Magnets are strange in the fact that they have a negative and positive field within them but if they break off these fields separate with the magnet. Meaning if you break a magnet it becomes its own bipolar magnet. So the real question is would a larger magnet on one side change anything as it would increase the area that was magnetically charged?

Congratulations on the new setup! I was wondering .... Alexey said something about the Tesla Coil running at 2508 Hz, and his schematic has (it seems to me anyways) a frequency adjust possibility. Nearly all ZVS I've seen does not have the possibility to change frequency independently, sure you can change the input voltage and that also changes the output voltage. What is your take on this, sorry I haven't watched the video yet - but I will soon. Take care, and thanks for the share :ø) Edit - 250kHz, not 2508Hz

Have you looked anymore into the high Q tesla extra coils I recommended? If built properly you can get a Q of 200-300, though that's only if you give it extreme optimizations to reach close to that including the choice of frame and environment.

Hello, I can see that you have one capacitor, maybe you need two as the other guy had in his video? It may be the extra capacitor will do the trick ? Keep going 👍🏻

We see the effects replicated with different components i.e. the florescent tube lights up at proximity to the Tesla coil like it does with the Graviflyer. Your variac should be your best friend to replicate with other materials and components. The signal generator should allow you to get the tolerances right so that you know how much voltage and amperage is necessary. Everything is clearly presented so you can see what is happening with the energy.

Your wires are way too thin for sure and this is the problem I’m having, we have it wired wrong. I’v been playing with a fly back and I think your cap is wrong too I dont know there is so much im finding out. Thank you this helps. I’m having a huge problem with the Tesla. Cause I never built one and we need 1mhz

👀

you should also look at getting high voltage probes for you scope. so you can see phase btween tesla coil and gravifyer

If you increase The amperagem ?

12v DC copper car battery cable for your coil hookup. ideal(also use solid lock grounds) Thermal displacement. your caps are not in tandem use redundent power wires.

try increasing air gap between primary and secondary. larger radius on tubing. you could increase inductive transfer with flat tubing.

I wanted to mention about the Witts Ministry. They supposedly have anti grav and many other stuff! And yes, it is a Christian organization!

any news on the new mic/cam?

awesome you get there a 4 feet spreading is wild lol.

that thging in tghe vice behind it looks more promissing.

What you are witnessing is an un-balanced set of rotating masses with sloppy bearings that torsion against each other, flexing the plate between them.

Check how long your wires are- perhaps tune signals this way. ruclips.net/user/shortsaSSqrddG6B0?si=5UBUSXEufjpTVz_L Copper tubing effectively delays with coil length I haven't seen spirals, but it might speed it up. ruclips.net/video/cBZKziM0vlI/видео.htmlsi=dDsqhHYqUE32PlU8

You got email? I got few suggestions

You need to put some loctite on all them bolts anything that's threaded you some threadlocker tighten that thing down Make it rigid also the goal is to move spread space not air

great video i love it come them test coming cant wait until you put some power through it.

lol

In the vids where Alexey uses magnets on top, he has the magnets on top of the top rotor so the magnetic field continues in the same direction from the bottom. So N up on bottom and N up on top. It does make for a stronger magnetic field, and a stronger ion trap in the center, but maintaining resonance is still very difficult, which is why he went to just magnets on the bottom.

магниты не правильно стоят нужно магниты направить в нужное русло

what does this thing do?

\-/upper inversese, /+\ lower inverse.

try using a ring made of noedynium magnets maybe..?

Do you have Alexey's diagrams and instructions?

Perchance could you show a high fidelity waterfall sonogram!?

cool sound effect generator!

That smoker gives the smoke too much initial velocity, it's hard to see what direction the device pushes it when the garage fills up in a few seconds hehe. Smoke tests are a pain to get right and a bigger pain to get rid of it for a re-test. Other RUclipsrs usually use a bag filled with smoke, so that they can give it minimum velocity and minimum distortion/spread of the smoke column.

With the additional cogging you’re going to draw more current to the motors. Maybe this works but now you have to spread the plates out farther. Wondering where that sweet spot is. Interested to see how the high voltage effects with magnets top and bottom vs just on the bottom. Thank you for sharing!

One thing about this channel is that I learned a lot about scientific exploration. Also, Nathan always inspires me to push past the artificial boundaries set by others.

I don't see any vortices in the cloud. Seriously, if that's all the air it can move, it's never going to fly. We've all been duped by mediocre photo shop and video editing.

No coanda effect

if you could make the waves bend like a tulip, maybe. I wonder what this would do with a housing, but Alex did not have one.. really mind boggling.

love the new look! keep going.

Thank you for all your hard work great job. It’s fake, that Russian dude is a facker.

If I'm being brutally honest I don't think this device is real, and if it is Alexi has never revealed a key missing component or principle, from what I hear he sold kits to people and they never worked which is extremely dishonest and highly suspicious. There are ways to remove the effects of mutual mass acceleration (gravity) but I don't think this is the right approach, one place to start would be the principle of getting a gyroscope, a dome shaped bowl, and a tub of water, put the bowl in the water and then place the gyroscope on it after spinning it up, you'll notice that as the gyroscope reciprocates the bowl slowly begins to rotate the opposite direction, this same principle applies to early stage field propulsion craft and their interaction with the Aether. There are some sources that might interest you for more advanced development of field propulsion, such as: Gravity Control With Present Technology and How to build a fly saucer and save the planet by David Alzofan (I don't agree with his explanation of electron particles because those just don't exist, but the info is still interesting) The work of Thomas Townsend Brown and his asymmetric capacitors. Shape Power by Dan Davidson, there's some research in there on gravity control effects. StarDrive Engineering by Mark R. Tomion - Archer Enterprises 2001. The physical books cost a fortune, fortunately they can be downloaded online for free. Tomion also has a patent "US6404089B1 - Electrodynamic field generator" of course since this is a US patent whatever is in there won't work out of the box, stuff like that is either a hoax or its in code. I also have my own ideas for 3 other types of field propulsion based on the info of some other folks which I've not mentioned here, it's a big field.

unfortunately there is no hope! 😔

Bro I know how bad you want this thing to be real, but you could spend your time and resources doing something that will work in the end. This is just a rabbit hole that goes know where...

If you could not reproduce Alexi's so called break through by exactly cloning his Graviflyer, then his videos are clearly a hoax...

When nature relaxes it's energy state (stress energy tensor) it forms hexagonal prisms. I think the magnets should be together on one disk to get one hexagonal fractal pattern. This also isnt fighting itself like counter rotating magnets making reaching the reasonant frequencies actually achievable. We saw from the previous video how when the voltage is increasing or the disk is accelerating more sparks/plasma collect on the bottom disk. This makes me think the magnets only assist in collecting negative charge there to create an electrostatic repultion with Earth. Build to 7 tesla from REASONANCE and it will float. See, i think low voltage input is all that is needed but the output must be very large voltage. Thats my theory at least. When i was abducted i remember a low hum/pulse that was less than 100 hz. Probably close to 50hz. For the piezo buzzer I would think its important to get a cymatic frequencies that follows a similar hexigonal pattern as the magnets but this one is mer speculation. I think this because it starts reasonamting with itself when being tapped. So their is a phase change till the waves stack just rights. I would try frequencies that sum to 9 first. All intervals of nine are also composed of an interval 9 when its digits are summed. In other words mathemathics forms fractals with 9. Fractals follow spirals. Spiral em fields for plasma torroids. This is the end goal. One large bose-einstienien cold plasma that reasonates to bend gravitational field lines. (Really all Electric field in my opinion but whatever)

Well that's interesting 😅

What is that thing in the vice in the background? Looks interesting! Keep up the good work!