Видео

That is one of the most god-awful ugly piping jobs I have ever seen if I was the owner of that house I would make you repipe it plumb level Square the installer should be ashamed of themselves.

No my work the control

No hangers/ bracing on the supply lines sloppy looking job.

This was an exact replacement for the old one that lasted about 10 years. ruclips.net/user/postUgkx7yWIKcrbA9KMHkGSfcgxW2lsjHT6B8Sh The top of my mitigation tube by my roofline was just a 90 elbow which allowed too much debris to fall down into the fan, eventually ruining it. Without this issue, I bet it would have kept running another 10 years. When I replaced this fan, I added an extra elbow joint so the top tube now it does a 180, which should solve that problem. The radon guys around here wanted to charge me a $300 diagnostic fee, then parts/labor (probably close to $600 total). I installed this all by myself in about an hour for the cost of the fan; it would probably be even easier/faster with two people. FYI the manufacturer's warranty greatly differs depending on whether you install it yourself (1 yr warranty) or have a licensed installer do it (10 yrs).

Sorry, maybe functional, but horribly piped.

Thank you for the video!

wtf kinda install was that? i’d have y’all strap all that shit down and repair the sheet rock

That looks like shit - I’d be pissed to come out and see 2x6s with pex piping hanging with foam insulation…

Might as well go watch the video about how you get the water temp over 120deg F. Nobody thinks to do that during the initial setup, but you're probably going to want it up around 130-140deg.

Ed bassmaster

Like others have stated, it is not a very clean install. I have no doubt it works and is up to code, but I would be pissed if I paid for a professional install and this was the result.

if the side of the water heater is leveled, isn't bottom of it should be level too?

Hello I live in alameda county in California. Does anybody know if it it’s ok to run a pex piping for tankless pipe? For the hot & cold? Rather than stainless braided flex one?

Ugly installation work. I think I would go with someone more professional

Sloppy crappie work

Bent the shelf support while removing old heater and left the old one???? What you do, hammer it into shape....LOL

That’s a crap job install

Here is a video of our Off-Grid Rannai Tankless install. ruclips.net/video/4MKDE-BT7nk/видео.html

Are tankless water heaters cheaper than tank water heaters

I am getting a code 11 on a new unit. Model v65i. It has never worked.

What is better a separate boiler and water heater or a Rinnai combo unit?

My Dad would kick my butt for doing something so sloppy!!

You the protectional .this luck like Mike mouse jods

I'm a sinner JESUS please forgive me for all my sins I know you shed your Blood for me on the cross at Calvary. Thank you JESUS for my salvation they your Blood. I love you JESUS. Romans 10:5/10....

our on demand / tank-less water heater system is messed up. This one has a recalculation pump. It seem we only get hot water when another hot water tap is open than it seems to heat water fine than after a minute the water flow completely shuts off. If I turn the hot water valve off for a minute or so it will turn on with good flow for about a minute than completely shuts off the water flow. Anyone every had this issue, and how did you fix it ? Thanks

This is why I do shit myself. I’m tired of paying people top dollar for subpar work. This whole install looks sloppy. I would not have accepted this.

Could you do a video on how to do the wiring when adding a grunfos gtk15

Dont need an expansion tank on a tankless hot water heater

You would not ask a videographer to install your plumbing. Why do these plumbers think they can do a competent job making a video? (They didn't).

Definitely would’ve brought my supply water closer to the corner and made it look neat lol

You could have taken the extra 5 minutes and leveled the water lines....

This dont need a condensate line?

That’s some sh!++y ās$ installation!

’Im currently having built a log cabin on a trailer from Lancaster log cabins. Included in my cabin is a regular tank water heater, but I sprung extra $ for a tankless water heater. They install the water heater outside on the rear of the trailer. In speaking with a few friends, most have agreed concerns about the water heater freezing in the winter months when no hot water is sought. I know nothing about these systems, although I’ve attempted to find out info on them. I can still have them put a tank water heater in, I’m not sure which way to go. I’d like to use the cabin in the winter months, It is going to be in the poconos (Pennsylvania) I may try to winterize each weekend I’m done using. In your professional opinion would it be better for me to just stick with the tank water heater or get the tankless? Any info you can provide would be greatly appreciated. Oh the tankless water heater is made by rinnai on demand V53dep

Water lines looked ugly

Very shitty install, they obviously don’t take pride in their work

Not that professional-looking of an installation. Should have patched the drywall and painted the wood.

This looks awful. At least try to cut your 2x6's straight? Wouldn't give me great confidence in the rest of the install.

Code requires at least 18" of copper pipe off of hot side because of water temperature, after that you can turn into pex.

Thanks for being a good human being Joe!!!

What a mess of an install. Hope the duct was cut because none of the white part isn’t rated for exterior. 🤦🏻‍♂️

Tankless, hello, tankless... Where does water expand without a body of storage like a tank. Tankless = no expansion tank. And you call yourselves professionals?!

Crappy install

Looks pretty sloppy to me

I JUST INSTALLED MY ru130in RINNAI, I CAN JUST GET HOT WATER IF I TURN 1 FAUCET AND A SHOWER OR 2 FAUCETS AT THE SAME TIME.. ANY CLUE?

Waiting on more project videos

installed like pros!

I don't have a gasline my house :(

Are they better than hybrids

Pick me up I wanna help lol