- Видео 159
- Просмотров 345 731
Esakin Diesel Performance
Добавлен 7 фев 2011
Diesel Performance Installation / Removal , many random stuff
EcoDiesel Timing Chain setup
This video runs threw the basic Timing Sequence for 2014-2021 3.0L EcoDiesel A630/L630, for Ram 1500 , Jeep Cherokees.
Specialty Timing tools are required. As shown in video.
Specialty Timing tools are required. As shown in video.
Просмотров: 19
Видео
2015 3.0L Ecodiesel Straight pipe
Просмотров 19612 часов назад
2015 3.0L eco diesel 60hp ppe tune Straight pipe turbo back 3” New turbo 3” cold air intake 147km
2018 6.7 Cummins 3500 Burnout
Просмотров 7752 месяца назад
2018 6.7 Cummins 3500 , BD TorqueMaster 68RFE rated 700hp Billet inputshaft / output , BD Bigstack , BD Proforce 3D Torque converter , EFi Live 5pos sotf , deleted studded arp 425 , 33/13.50/22, 4” bds 4-link lift , bds dual steering stabilizer, GoRhino
1957 Fargo G56 Cummins
Просмотров 312 месяца назад
1957 Fargo Cummins Swapped G56, 3500, 66mm Industrial injection 66mm Silver Bullet turbo,
2020 KX450 Burnout
Просмотров 712 месяца назад
2020 KX450 Burnout Launch control , shredding rear tire
Compound turbo G56 07 Cummins driving
Просмотров 17 тыс.3 года назад
2007 Cummins Twin turbo / Compound turbo what ever you wanna tickle your fancy toe slang 3406C 78MM Non W.G A.R He351Cw 67MM 120hp sticks Intake horn 3” G56 Lots done to truck mild acceleration all with 50% throttle truck boosts fast quick, big turbo supply’s out 30psi @ 4” diameter into the 67mm
2007 Jetta TDi 2.5” Straight pipe
Просмотров 1,9 тыс.4 года назад
2007 Jetta 1.9L TDi BRM EGR Delete , ASV (Anti-Shudder valve) Delete 3” Race intake plenum 2.5” straight pipe exhaust. No mufflers or cats Into a 3” long 3ft Exhaust tip
2015 TDi Jetta 2.5” Straight pipe
Просмотров 4,6 тыс.4 года назад
2.5” Exhaust straight pipe Volkswagen Jetta TDi Highline, Auto trans. AFe cold air Intake 2.5” downpipe aswell, all the way back. 3” Longer exhaust tip. Malone Stage 3 Tuning. Volkswagen Jetta TDi Deleted and Tuned
Cummins Low Oil pressure fix!
Просмотров 12 тыс.4 года назад
This will cover all 5.9 /6.7 Litre cummins engines. From years 1989-2020. Truck will run fine all day once it’s started and pressure rises, Initial issue was truck starts Oil pressure drops, Touch the throttle 1% APPS and the oil comes up, this was air being sucked back threw the two oil holes off the cooler, Oil pumps fine. Truck would run 60-80psi cold, warm 30-50psi depending on load and tun...
2007 5.9 G56 Cummins Ram 2500 Shifting
Просмотров 3 тыс.4 года назад
2007 5.9 G56 Cummins Ram 2500 Shifting
3rd Gen 2nd Gen Cummins Manifold swap
Просмотров 8 тыс.5 лет назад
3rd Gen 2nd Gen Cummins Manifold swap
Gotta see some more 6.7 Cummings content, my buddy’s got a 68rfe with some transmission issues…
Can’t wait too show meee-maaaa she’ll eat this shit up 💯💯💯💯💯🤣🤣🤣🤣🙏🏻🙏🏻🙏🏻🙏🏻🙏🏻
Fucking mutts barking in the neighborhood again🐶🐶💯💯💯 #6.7 #cummings #realhoodshit
The eco-diesel she tells you not to worry about 😅😅😅😓😓💦💦😰😰
How many whisky cigarets does this service require. Cheers.
A few packs.
You put a stock 2nd gen exhaust manifold on a 3rd gen?
Yup.
Is that CP as in Canadian Pacific?
Uhh that’s a 4th gen steering wheel right?
@@ASOff-Road-ur3xu yes it is
@@EsakinDieselPerformance How’s that swap ?
@@ASOff-Road-ur3xu works good no issues
She's gnarly!! Nice truck!
I’d say
just a few more years and the vw will stop giving people new emissions systems for free and I can do this for a profit, 2015 has the best dieselgate warranty I have had over 8k in work done for free on it + the mandatory rental car is nice
Sure brings back memories
Should the fuel be spraying out with greater force?
No I don't know what this video is showing lol
@@pottnah6152 I think he is trying to show that fuel is passing through the pump since it made it to the return port but not enough pressure to "pop" the injectors to spray. @FoxRx really should give a hint to what he is trying to show.
Mine does the same.. diesel shop says it’s normal.
Did she make wierd screething noise off and on.? Wondering if i just have a bad oil pressure sensor. My new truck says about 2psi but i unplugged the sensor and replugged it back in and went to 40psu then dropped back down to 2psi when sitting idleing. Sick of this shit box already
Seems to have a fairly large hole in it.
Mine will spit out fuel as soon as I turn the key on
Same. Trying to figure out why.
how did you swap the steering wheel?
Did you pop a p0153 code?
I just spun a bearing in my 1990 Civic. I cut strips of sand paper and then folded them in half length wise. Then used them to sand and polish my rod journal. Started with 400 grit and ended with 2500 grit sand paper. Plastigauged it with new bearings and shimmed my oil pump pressure relief valve spring with 0.1" of washers to bump oil pressure up. Runs good. But this only works if the rod and crank didn't get to hot and warped.
This a 5.9 or 6.7?
5.9 07
@@EsakinDieselPerformance nice
Could this be an issue, to cause fuel filter bowl not to fill? Or should i just go straight to fuel pump Stock system.
Did it fire right up? I just did this myself and have yet to get it started i jave fuel pressure all the way up to the lines
Could you clarify exactly what's Happening Here. This is where the return line goes right? Are you checking to see how much fuel is returned to the tank? It appears that you're getting full return right?
So how would you know if its bad . Do these shoot out with a lot of pressure from there .
?
Runs like shit you can tell it isn’t running correctly
What’s done to the trans?
Everything
@@EsakinDieselPerformance I’m looking to put a s472 over top of my 363 and the truck is o ringed 625 studs valve springs sump and air dog. It’s got a Valair dual disk and I’m wanting to run it on just stock fuel what else should I do to the trans so it doesn’t break?
The Jeep wj engines? Wow
Thanks for posting, I have a 2007 with g56 , how much faster does the turbos spool up compared to stock?....my opinion stock takes it's sweet time to spool up .
Y u shift so much
Whats all the bs dangling in the truck ?
How did you get your stock turbo to whine like that?
Magician never reveals their tricks 💯💯💯🙏🏻🙏🏻💼💼💼💼
When you installed the new pump did you check to see if it returned fuel like this?
No. If cranking and trying to start if full return and High pressure line isn’t putting out it’s toast
Mine is doing the same thing.. so you replaced your cp3 and it fixed it until you had an injector problem?
You have single mass flywheel or duel mass? My duel mass slips when i turn my tune up
Hello Fox remember me? =) Seán!
What did u have to do ? Did u just Swapped it and was it a perfect fit, or is this a after market
Are you in the Battlefield 2 modern combat veterans discord group? There is over 250 people including a couple old developers of BF2MC That are trying to get the game back online, let me know if your interested in joining.
What shifter is that? Very audible clicks. Do you have a aftermarket stick setup? Mine doesn't do that. Stock stick g56 with twin disk
literly just bhad this exact same thing happen i went strait for the bottom end it got one bearing pretty good and lightly on another put all back togather but oil pressure gauge would comply drop to 0 after 30-40 sec after start up so shutdown for almost a week on this till i found ur vid and when i looked exacly like urs id have been looking forever to find this failure for sure so thank you for posting this vid game changer
What happens if U dont put relief valve back there and run engine without it?
What downpipe did you use?
Fantastic! 😃 I have an ‘18 RAM 3500 SRW Short Bed 4x4 CTD G56. Bought new & now 36k miles. I tow a 14k gooseneck for my tractor. Thx for inspiring moving forward!👍
How do you get the turbo so loud?
just put straight pipe from turbo to back..u need to have the same inch tube all the way ....and where u go, ur turbo will do that sound
That moment when you know roughly what timeframe this video was recorded in when you see the mask hanging on the dash. God damn Rona bullshit!
So what kind of compound setup do you have? Second gen over under?
Home made, 2nd Gen manifold flipped, s430sx 78mm T6 on the he351cw 67mm
Reeeeeee
Love the buck knife in the vent… How else are you gonna hold your mask!?
We used to play bf2mc remember lol? Xxxibmxxxx?
Yo haha
@@EsakinDieselPerformance what you been up to?
Dude I haven’t spoken to you in ages lol
U use the stock charger?