Flsun Super Racer Direct Drive Upgrade!!!

Поделиться
HTML-код
  • Опубликовано: 13 янв 2025

Комментарии • 15

  • @SetSunStream
    @SetSunStream Месяц назад

    Hi, I bought the exact same printer with the same direct drive extruder from a guy on facebook. I have a question. I replaced the nozzle yesterday and I noticed that there was a little piece of ptfe stuck above the nozzle (inside). I haven't touched or fixed anything..I just screw the new nozzle in and it worked fine for 2 hours of print already...It should be Ok or I need to replace the ptfe tube with a new one that reaches the new nozzle? (I ask because I'm scared to fuck up everything if the filament starts to come out from above..)
    Great video and thanks in advance!

  • @AidenSimmokns
    @AidenSimmokns Месяц назад

    What are the m3 insert length like m3x5x4

  • @nesnduma
    @nesnduma 2 месяца назад +1

    Why not having chosen a Volcano hotend? It would have been close4 to the factory one.

    • @hwbprints7384
      @hwbprints7384  2 месяца назад +1

      @nesnduma this is the factory hotend, we just replace the heater block

  • @Slyv3r93
    @Slyv3r93 4 месяца назад +1

    The housing must be printed with ABS, correct?

  • @moosebrain
    @moosebrain 2 месяца назад +1

    where did you find the fan ducts?

    • @hwbprints7384
      @hwbprints7384  2 месяца назад

      @@moosebrain I think they are on thingaverse

    • @moosebrain
      @moosebrain 2 месяца назад

      @@hwbprints7384 thanks. they're there! called FLSUN SR - Fan Duct (Ultra Narrow)

  • @brandonbell4133
    @brandonbell4133 6 месяцев назад +1

    so what about the firmware changes

    • @hwbprints7384
      @hwbprints7384  6 месяцев назад +2

      @brandonbell4133 when you switch out to the orbiter you will need to set the voltage to .850 and the steps are 690, klipper you will need to Calc the rotation_distance

  • @argusz
    @argusz 8 месяцев назад +2

    So... you are using a Volcano heatblock, not V6....

    • @hwbprints7384
      @hwbprints7384  8 месяцев назад +1

      I use what works

    • @ryanlamb3790
      @ryanlamb3790 8 месяцев назад +1

      Nerd

    • @AnthonyM1
      @AnthonyM1 4 месяца назад +1

      @@hwbprints7384 Great response...as I life by that as well