PASS THROUGH SEAT INSERT/BEZEL INSTALLATION FOR 4 POINT HARNESSES ON 2020 RZR TURBO S FACTORY SEATS

AS WITH ALL MY VIDEOS I TRY TO GIVE THE MOST INFORMATION IN THE LEAST AMOUNT OF TIME AS POSSIBLE. IN THIS VIDEO I GO OVER THE INSTALL OF SOME PASS THROUGH SEAT INSERTS FOR THE FOUR POINT HARNESSES FROM START TO FINISH WITH TRICKS I LEARNED DURING THE PROCESS. I INSTALLED THEM BECAUSE THE HARNESSES WOULD ALMOST FALL OFF THE SHOULDERS OF MY DAUGHTERS IN THE BACK SEAT. WE ALSO PUT SOME SHOULDER PADS ON THEM TO MAKE IT MORE COMFORTABLE ON OUR SHOULDERS.

[@GadsdenJL]

Thank you.
I'm installing these in the back seat of a jeep jl for the kiddos.

[@TM_Rags]

I watched your video to help me with my installation today. Great information! I will say, I used a gig saw and had the seats cut out in less than 10 minutes. It literally takes longer to tape the template to the seat than it took to cut them out. I used a large bread knife from the kitchen and cut out the foam fairly easy too. Now, getting the two pieces of plastic to go together perfectly was a little more of a challenge. Each seat probably took about 20 minutes from start to finish. Thanks for the help!

[@hillbillyhangover]

Thanks for the vid!!!! Going to have to do this!!