Mercedes OM605 OM606 Superturbo Setup Building Guide Part 1/3
HTML-код
- Опубликовано: 4 окт 2023
- In this video I try to give you an overview on the repair and maintenance work which should always be done prior to a Mercedes OM605 OM606 superturbo engine build. Also I show my opinion on a nice 250 to 300 hp setup on the OM605 / 300 to 360 hp setup on the OM606. This is the first of 3 videos where I want to cover all the important information of building an OM605 OM606 engine to a certain power level.
Check me out on Instagram:
/ w202_performance
/ w202.store
Check me out online:
czsmotorsport.de/
w202.store/
Check me out on Facebook:
/ fundametrik 
Авто/Мото
Great to see you back!
Alot of good advice here, thanks for that and perhaps a compression test of the engine before work begins, first test at room temperature and then one at operating temperature. The egr and crankcase vent system tends to cause a lot of build up onto the intake valves which hurts airflow, as this material falls off the valves into the combustion chamber it can affect the seating of the exhaust valves. Many of these high mileage engines really need de-carb and valve job too. Keep rolling...
Very interesting. I'm looking forward to part 2 😊
Great video!!! Clearly and easily explanation of diy auperturbo build. This is what I'm looking for build my every day use c250. One more great video.
Great guide!
Stabil das du ausführliche videos machst
Great Work 🎉
Big thumbs up 👍. Very detailed and nicely explained. I am about to build my first OM606 so i am taking notes haha. Looking forward to tne next part ! Also i would advise to always change the rear main seal while the engine is out. Mine is leaking on my 606.😅
Amazing knowledge
nice, im curently doing the same project for daily it. see you soon !!
Nice guide for new guys is std building!)👍
Thanks, this is exactly the build advice that I needed. I am fitting an om605 into a Toyota landcruiser troopy
I'm putting one in my hilux
I also have an extra cab Hilux and if I had discovered these OM605 and 606 engines earlier I would have also fitted one - instead I have rebuilt the original 2KD engine. Do you think that the OM605 will spool fast enough with a G25-550 turbo and a 7.5 mechanical pump?
Hammer!
just found your channel, very good.. im running a standard ecu pump on my om606 with a stage 2 tune and a td4e turbo, so running about 280-300ish bhp, so I guess my first call would be to upgrade my ecu pump but what elements should I put in... maybe 8mm and would the car still run ok with the original stage 2 tune and bigger pump elements thanks
Thanks for the advice, about the 7mm elements, where can i find them if i want a local dieselist to build the pump for me?
Ty
That water line should be connected regardless of water cooled turbo or not. It helps cool the rear cylinders more evenly.
I want make this engine for boat(marine).Please advice wich turbocharger suit me better Holset HX35 or Garrett g25-550.Greath video and knowledge BTW.
🙏🏼😍
Hello there! I am about to install a turbo on my om605.911 engine. I am gathering information about how to do it properly at the moment because I am new in this stuff. Anyway, can you give me any advice thats not mentioned in this video specifically for that engine?
How to do the oil lines?
Hello, at what rpms the g25 550 will start to make positive pressure on OM605? I have one on Toyota Landcruiser 70 and i am torn between g25 550 0.49ar iwg and Borg EFR 6258 0.64 T25 iwg. Target is to have some boost below 2000rpm, if possible.
what are the modifications needed to achieve more than 450hp+ . Thanks for advance .
Great info! Thx any advice on an OM602? I’m hoping 7.5mm meken and stock turbo for a while then upgrade turbo and add intercooler later if possible
I think you will have to keep fueling turned way down. The stock turbo isn't going to keep up with the fuel and egt will go through the roof. Especially without an Intercooler. I don't know 602 very well but a 603 turbo isn't going much more that 180-200hp without being out of its efficiency range.
What do you think about the om612
Toto wolf building a om606 😂
Hello , I have a question , I have a w210 2.9 om602 do you think that engine can raise the 250-270hp?
What is your timing ?
14.5 atdc?
Thank you
At what pressure is the wastegate triggered?
wie hast du die turbo drehzahl ausgewertet?
Great video my new friend !
Liked/Subscribe !
Hey wär es möglich dass du mal Videos auf deutsch hochlädst? Die sind echt super aber mein Englisch ist nicht das beste😂
Dude I need torque numbers not hp so much diesels are about torque torque torque