How to install SuperATV's RACKBOSS 2 0 RACK AND PINION on the RZR XP 1000

Ready to install our new RackBoss 2.0 Rack and Pinion on your RZR 1000? Braden will walk you through the process and have you up and running in no time. This rack is upgraded to be the strongest, most durable rack on the market. It’s also made with our X24 Tech-a dual-bushing design you can’t get anywhere else. It reduces the wear you’d see on stock by over 50%. With SuperATV’s RackBoss 2.0 Rack and Pinion installed on your Polaris RZR XP 1000, you can run massive tires and tackle deadly terrain.
00:32 - Remove tires
01:23 - Remove existing tie rods
01:48 - Remove hardware connecting steering shaft to the pinion shaft
02:32 -- Pry the steering shaft
03:11 - Remove nuts securing the old rack and pinion
03:56 - Pry the old rack and pinion from the machine
04:35 -- Unboxing Rackboss 2.0 Rack and Pinion
05:35 - Pre installation notes
05:58 - Install the RackBoss 2.0
08:08 - Tighten all your hardware
08:37 - Align pinion shaft to steering shaft
09:09 - Installing tie rods to RackBoss 2.0
12:27 - Reinstall any hardware or components you removed
12:41 - Set the toe
Need to pick up a new rack and pinion for your XP 1000? Grab SuperATV's RackBoss 2.0 on our website. www.superatv.c...

[@christophercalovich3686]

Will this work will your guy's long arm kit and your portal's?

[@Hardcoreslash]

My kit came with a taper stud and a straight stud. Which do I use? My threads are maxed out on my rods and I still have toe in. Help please!

[@SuperATVMedia]

This will all depend on your model. Please give us a call if you are still needing assistance with this, 8557433427.

[@joshuapepe4146]

Yeah when will you all make one for the can am defender

[@DaGreatWizz]

Mine just came today. To me it doesnt look like the paint line matchs up on the new one. What steps do I take to correct this?

[@SuperATVMedia]

Please give us a call or send us an email with photos; 855.743.3427 or [e-mail]

[@Hardcoreslash]

same here. should i do the same? @@SuperATVMedia

[@opengchris18]

why would you not install the stops?

[@SuperATVMedia]

It depends on what type of riding you are doing. The main purpose in the stops is to prevent oversteering, especially in reverse. If you aren't doing any riding that requires extreme turning angles or are very conscious of your steering angle, you could leave them out.

[@tylerlong4738]

So ur not using the steering stops

[@SuperATVMedia]

For this application, we did not install the steering stops. If you plan to install them, it's best to do so prior to installing the rack. Pull the boot back from the rack body and clip the stops onto the steering piston, secure the boot, and proceed as normal!

[@opengchris18]

@@SuperATVMedia so what is the advantage to not installing the stops?

[@ryanwilson964]

Already answered above. Good answer. U will find helpful