Is it possible to select a start point instead of changing all these parameters? Is there a Video? I need this information for 2D pockets and 2D and 3D HSC. THX in advance
The highspeed toolpaths have many options for tool entry, too many to cover in a youtube comment. Some videos on our blog discuss these options. blog.caminstructor.com/mastercam-dynamic-milling-part-5 is a good start. I should also add to the previous reply for the 2D pocket, you also need to check the ‘Center on entry point’ box on the entry motion page.
Just saved me a lot of frustration. Thank you very much.
Glad it helped
Thank you so much!!! :D
You're welcome!
Is it possible to select a start point instead of changing all these parameters? Is there a Video? I need this information for 2D pockets and 2D and 3D HSC. THX in advance
Yes. You can give 2D pocket a location to plunge at, or perform the entry motion, by adding a point to the chained geometry.
CamInstructor Thx for your answer. What about the HSC pockets?
The highspeed toolpaths have many options for tool entry, too many to cover in a youtube comment. Some videos on our blog discuss these options. blog.caminstructor.com/mastercam-dynamic-milling-part-5 is a good start.
I should also add to the previous reply for the 2D pocket, you also need to check the ‘Center on entry point’ box on the entry motion page.
This part was hell for me
It should run, it may not run well on more complex parts.
i program this with slot mill...way easier IMO!!! i hate pocket