If you cannot move the valve then undo the bolts by 2/3 turns then start the engine with electrical plug connected. The pressure will free up the fitting.Only undo the bolts a couple of turns and make sure the engine is warm
since you seem familiar with 270 cdi, do you have any idea if there is separate tube or line from turbo to egr? i have mine turned of in ECU and car has just an odd whine to it because gases still go to egr circuit and i am looking at blocking it off As close to turbo as possible. thank you
@@eduardopinheiro644 Thanks, your video was very helpful. I tried to unplug and drive but still have power loss, and black smoke. Only error code is p0404 egr. Could my egr be stuck open or closed?
Update: My EGR was faulty. I took plastic cover off ontop of egr and got someone to rev the lever was not moving. I replaced with used part and now fine. I Still had black smoke but that was a split at bottom intercooler pipe.
@@eduardopinheiro644 I have a mercedes e220 cdi from 2004 automatic box the car loses strength and sometimes in low rotation to climb fails a little but on motorway the speed 120 tá normal just makes a little black smoke
Excellent work great video eye-opener for people that not familiar with EGR valve. Thank you.
Thank you
Many thanks,I'll do this myself
Thanks for your video, shows where the EGR valve is and how easy it looks to clean it. 👍
Thank you
Doing mine now & this vid is great, well done Sir.....
Now if i can get mine out !!!.
You welcome
If you cannot move the valve then undo the bolts by 2/3 turns then start the engine with electrical plug connected. The pressure will free up the fitting.Only undo the bolts a couple of turns and make sure the engine is warm
Top
Thank you for your video it is very simple, clear and useful.
Clean work 👌
Thank you
Thank you. Good video.l am just about to do this job. It will be easier thanks to you
Glad it helped
Very good video. Good camera. Is there a gasket the in between or not ? Someone told me there is a metal gasket. I have 2006 E320 CDI
Hi Argient, mine is a E270 and didn't have any gasket in between. Thank you for your subscription
one rubber O ring
Good video thank you. mine is the 320 CDI. Had no gasket either.
since you seem familiar with 270 cdi, do you have any idea if there is separate tube or line from turbo to egr? i have mine turned of in ECU and car has just an odd whine to it because gases still go to egr circuit and i am looking at blocking it off As close to turbo as possible.
thank you
I don't really remember as I had the merc 4 years ago, sorry mate
Me gusta mucho este vídeo.
Muy didáctico y bien explicado.
Gracias
gracias
Very helpfull, thanks.
I am glad i could help
Thank you!!!
Luckily my W211 does not come with an EGR!. For a while I mistaken the secondary air injection unit for an EGR.😂
Hahahha:-))
👍👍👍👍👍👍 Nice!!!!!
Thanks 👍
i have a 2009 E350, i have taken the two bolts out but the EGR wont budge. Any suggestions ? Thanks
It's stuck, try w40 around and try to move to each side, need some persuasion
Thanks for you video:)
Thanks for this video!!! 👌👌👌👌
Most welcome 😊
Harun will you send chloe Coleman actress leviathan 1989 from RUclips to share button twitter use app twitter
I removed the EGR valve and cleaned it. When I put it back. It did not work any suggestions, when I removed it and then worked again.
Check the connections,if ok ,then could be intermittent fault on the EGR
Gracias me costó bastante sacarla
Now you can clean it every 6 months
Do I have to disconnect the battery before removing? Thanks
No, you don't.
good video thanks bro
Thankyou
You welcome
how is it possible to remove it so easily
If stuck, a few taps with rubber hammer and should come off
Hi. Thanks. Did not succeed. The EGR stays like stucked in. Even bumping it with a hammer....didn't move a mm...
Well, that's happen, the cleaning is a preventive way to prolong the life of the egr, but sometimes is too late.
U mean it has to be changed? But then how to remove it? Bumping it with a hammer?
Try a few taps with a rubber hammer, don't hit the plastic housing on the egr. Try it to see if helps
U are very kind. I thank u a lot and wish I a GOOD day
Hello am driving ML 270 cdi where is EGR valve located?
Hi see this video its shows where it is, go to youtube and type ( ML270 W163 GOOD EGR VALVE), hope this helps
Grazie ottimo tutorial✌️✌️
Heló torque specificacion? please
no torque needed, no torque settings for egr
I cleaned egr valve but still have power loss and black smoke can I unplug and drive it to check if I have a faulty valve
I think so
@@eduardopinheiro644 Thanks, your video was very helpful. I tried to unplug and drive but still have power loss, and black smoke. Only error code is p0404 egr. Could my egr be stuck open or closed?
not always you can save your egr, it may need a new one.
remove it forever with the dpf and disable with ecu
Update: My EGR was faulty. I took plastic cover off ontop of egr and got someone to rev the lever was not moving. I replaced with used part and now fine. I Still had black smoke but that was a split at bottom intercooler pipe.
I have a 05 e500 where is egr valve located?
Not EGR e500
Bom dia qual foi o sinto ma para limpar a egr? Um abraço
Nao entendo
@@eduardopinheiro644 Good morning what was the symptom you had to clean the egr? Tanks
@@eduardopinheiro644 I have a mercedes e220 cdi from 2004 automatic box the car loses strength and sometimes in low rotation to climb fails a little but on motorway the speed 120 tá normal just makes a little black smoke
black smoke pode ser injectores, uma fault comum, mas tem que ser investigado primeiro
it's not so easy
it will broke before coming off