Vacuum Chuck Part 2: Adapter

[@longdriver2]

Thanks. Nicely done I'm going to make a few for myself.

[@edwinleach7401]

Great videos. You explained everything in perfect detail. Now I know what I need to do. Thank you.

[@stumpswoodworkingart7510]

Thanks , mine turn out great!

[@stumpswoodworkingart7510]

Did you need a vacuum Regulator.? Or is it not Necessary?

[@MapleCrossingWoodworks]

Since this is connected to a commercial vacuum pump, it’s not needed.

[@hawkeye10100]

A very well done video. Thanks. Are you using a vacuum pump or a small air compressor? Also, do they run all the time you are turning or go on and off?

[@MapleCrossingWoodworks]

Thanks, I'm using a RobinAir vacuum pump that I bought off of Craigslist. It runs the whole time I'm turning, it would not be able to hold the piece without constant pursue.

[@jean-paulroy1009]

Thanks for sharing. What is the brand of foam board you're using? Both videos are very useful

[@MapleCrossingWoodworks]

It was from the craft department at Walmart, that's all I know about it. Thanks for watching!

[@DonGamble]

What was the small faceplate you were using? Where is it from? Thx.

[@MapleCrossingWoodworks]

I bought a couple easy wood tools faceplates