I love the accuracy in the cuts near 3 ways and joins close to the angle as well as good speed .. most people on RUclips sacrifice quality with speed I see both here
Why all the gapes between the walls and the ceiling? Is there a arch light spec or relief bead that has to be installed? Always notice large gaps in videos from that side of the world.
What mud would be recommend to use in the United States and how thin should the compound be. Also if using USG all purpose joint compound how thin should that be. Not looking for a comparison but a formula or oz of water per gallon of pre mix. Does the consistency of the mud need to change for vertical walls compared to ceilings and corners. Just purchased and received mine a few days ago. I can’t get the tape to stick to the wall without it coming off and it’s extremely hard to push the tape out. I believe my mud is to thick. Could you confirm? Thank you.
Any good quality compound should be fine to use in the mud box as it is a very simple mud bath style operation. Compound consistency is key, you want something about the same as you would use in an automatic taper or for machine finishing internals. You want the compound as thick as possible, but you should be able to pull the tape through by hand without too much difficulty. Be sure to run the mud box on one tape wheel; this pins the tape to the wall to stop drag, and also allows a space behind the tape for the mud. If you run both wheels flat the compound can squeeze out both sides and drop on the floor. Unlike an auto taper you can control the mud flow. Experiment with how much you need to fill the joint.
@@Tapepro thank you for your great support. I also did some liberating on the moving parts that really helped. Is this something y’all recommend if so how often. Not very familiar with the term mudbath but I will do some research.
Maybe I 'll buy this tools. With the bazooka I do 25 meters around. How many with mud box ? Must I use the plaster in mud or can i use powder as 24h something very Low ?
The Mud Box has a mud flow adjuster so you can vary how much mud goes on under the tape, but I think around 15 - 18m per fill. It can be used with air drying or chemical setting (powder) compounds. It is very easy to clean and you can fill by hand.
It depends on your requirements. Advantages of the mud boxes over a bazooka: Less parts, can fill by hand, easy to clean, no dry tape, can control mud flow. Check this video comparison: ruclips.net/video/WvZ83enhmkI/видео.html
I dont really see where its superior to taping with a bazooka. I can pump my bazooka as full as i want too. Either completely full or if im tired maybe just 3 or 4 pumps to rest awhile. I can tape 9ft ceilings from the floor with my bazooka. I dont think i could do that with this taper. I just looks messy,having to open the box repeatedly and thining the mud super loose. My bazooka pump isnt nearly as messy. Ill stick with my trusty bazooka!
That's fine - we sell those as well. Some points to note: It is cheaper, less parts, can fill by hand, easy to clean, no dry tape, can control mud flow.
Would someone please explain to me why the lid and walls arent joined? Ive watched 5 videos of you guys down in convict land slinging tape and theres these huge fucking gapes in the ceilings! What is going on!!🤣
I love the accuracy in the cuts near 3 ways and joins close to the angle as well as good speed .. most people on RUclips sacrifice quality with speed I see both here
Cool mud box I like the design and how you can sit it on the box and fill it from the top, the guy at the end did a good demo, Great vid.
Thanks very much!
This dide puts the "pro" in TapePro. It's inspiring, I wanna reach his level of precision and skill someday.
That thing is cool! Love the clear mud box!👍🏻
Cómo se puede hacer para comprar esa encintadora
Why all the gapes between the walls and the ceiling? Is there a arch light spec or relief bead that has to be installed? Always notice large gaps in videos from that side of the world.
Why are there big gaps at the ceiling wall connections?
For cornice (cove, crown moulding).
Are these available in the states? Thank you, -Paul
Yes, contact walltools.com
TapeproDrywallTools hey guys I would like to buy that tools
2:17 it's when starts the best part of this video!!
Greeting from indonesia🇮🇩
What mud would be recommend to use in the United States and how thin should the compound be. Also if using USG all purpose joint compound how thin should that be. Not looking for a comparison but a formula or oz of water per gallon of pre mix. Does the consistency of the mud need to change for vertical walls compared to ceilings and corners. Just purchased and received mine a few days ago. I can’t get the tape to stick to the wall without it coming off and it’s extremely hard to push the tape out. I believe my mud is to thick. Could you confirm? Thank you.
Any good quality compound should be fine to use in the mud box as it is a very simple mud bath style operation.
Compound consistency is key, you want something about the same as you would use in an automatic taper or for machine finishing internals.
You want the compound as thick as possible, but you should be able to pull the tape through by hand without too much difficulty. Be sure to run the mud box on one tape wheel; this pins the tape to the wall to stop drag, and also allows a space behind the tape for the mud. If you run both wheels flat the compound can squeeze out both sides and drop on the floor.
Unlike an auto taper you can control the mud flow. Experiment with how much you need to fill the joint.
@@Tapepro thank you for your great support. I also did some liberating on the moving parts that really helped. Is this something y’all recommend if so how often. Not very familiar with the term mudbath but I will do some research.
Maybe I 'll buy this tools. With the bazooka I do 25 meters around. How many with mud box ? Must I use the plaster in mud or can i use powder as 24h something very Low ?
The Mud Box has a mud flow adjuster so you can vary how much mud goes on under the tape, but I think around 15 - 18m per fill. It can be used with air drying or chemical setting (powder) compounds. It is very easy to clean and you can fill by hand.
Good afternoon. Where can you get these tools? ALQUIMAX RENTAL
Where are you located? Check our distributors page.
I cant find it on amazon , Where can I order one here in the US?
You can buy from walltools - two models available: walltools.com/tapepro-mud-box-tpro-wmb-l/ , walltools.com/tapepro-mud-box-pro/
Great tool what is the name and where I can buy it please
Please contact a distributor for sales. See our web site for details.
Only if they were cheaper, probably sell 10x more!!!
Here in Canada it's around $1300 tax in
I'm in Washington PA is there anything around here or can you send me more information
walltools.com/wmb-l-mud-box.html
Available in the UK?
А щели между потолком и стеной как выготавливаете? Зазор очень большой...
Они будут подгонять карниз / бухту.
@@Tapepro cum pot sa cumpăr si eu multi ar cumpăra si nu știu
Donde la consigo quiero renovar mi banjo
Please check our distributors page.
Onde comprar
which is better mud box or bazooka???
It depends on your requirements. Advantages of the mud boxes over a bazooka: Less parts, can fill by hand, easy to clean, no dry tape, can control mud flow. Check this video comparison: ruclips.net/video/WvZ83enhmkI/видео.html
where can I purchase one?
You can buy from walltools
Better than bazooka ? It seem to be heaviest no ?
The taper is 2.9 kg, Mud Box 2.6 kg
How much are they I want one , how can I order it
Where are you located? Check our distributors for pricing: tapepro.com/distributors/
Donde se vende
Please check our distributors page.
I dont really see where its superior to taping with a bazooka. I can pump my bazooka as full as i want too. Either completely full or if im tired maybe just 3 or 4 pumps to rest awhile. I can tape 9ft ceilings from the floor with my bazooka. I dont think i could do that with this taper. I just looks messy,having to open the box repeatedly and thining the mud super loose. My bazooka pump isnt nearly as messy. Ill stick with my trusty bazooka!
That's fine - we sell those as well. Some points to note: It is cheaper, less parts, can fill by hand, easy to clean, no dry tape, can control mud flow.
Muy buena....me podrían decirme el costo
Aqui en usa te cuestade 35 a 60 dls.
Gabriel Cardenas pues dime en qué tienda para que compre 2, por qué yo que sepa cuesta $600 y solo online
Meguta la máquina de encintar
Would someone please explain to me why the lid and walls arent joined? Ive watched 5 videos of you guys down in convict land slinging tape and theres these huge fucking gapes in the ceilings! What is going on!!🤣
Cornice.
Hola mindami nomiro
Maxkil power
cuanto.kuesta.eso.violines
Why do you cut your tape at every angle? Cut it with your knife when you wipe and just go with the taper. So much faster!! You're welcome.
Where can I order this?
Please see our distributors page: tapepro.com/distributors