you could hot glue the esc down and it never comes off. just make sure to cover the honeycombs first and make sure its flat. after that you can glue the esc. also make sure that you clean the surface first so it sticks better. hope this helps!
@bs9two4 i was thinking about that! And im pretty sure I've done it before. But drilling 2 holes and just using a ziptie has worked out pretty well and it's super easy to remove the ESC aswell whenever you need to remove it. Thanks for the suggestion!
@ you could also get a medium thickness plastic sheet (about 4 times thicker than a plastic water bottle plastic) and put it on top of the hot glue and then double sided tape the esc. works well too
@Lukesrcs2009 im aware they will most likely bend if the impact is too hard. But I had these on hand so as soon as they do bend I will be going to RPM.
you could hot glue the esc down and it never comes off. just make sure to cover the honeycombs first and make sure its flat. after that you can glue the esc. also make sure that you clean the surface first so it sticks better. hope this helps!
@bs9two4 i was thinking about that! And im pretty sure I've done it before. But drilling 2 holes and just using a ziptie has worked out pretty well and it's super easy to remove the ESC aswell whenever you need to remove it. Thanks for the suggestion!
@ no problem!
@ you could also get a medium thickness plastic sheet (about 4 times thicker than a plastic water bottle plastic) and put it on top of the hot glue and then double sided tape the esc. works well too
Now i see why it had so many problems when u repaired it a few videos ago lol
@@superstatus2640 😂😂
Chase brase
its funny too beacuse i have a chassis brace its just not on there 😂
Get the RPM esc cage for your esc
@atkracing just looked it up, didn't know it was a thing! Looks useful tho. Will be looking into it. Thanks!
You would have saved it
Get rid of those aluminum arms. They will bend and break other things. Get some rpm ones.
@Lukesrcs2009 im aware they will most likely bend if the impact is too hard. But I had these on hand so as soon as they do bend I will be going to RPM.
Tracxas center brace will stop drive shaft benf on lcg
@jerrymulholland1842 i have one its just not on ATM. I think I might put it back on if that means they will stop bending
I use on both slash lcg after serval bendshafts none now