@@RecklessWrenchGarage I was hoping so lol I’m designing a set of gauges myself but I can’t find any good footage or photos of that blue it always looks super dim.
Did you have an electrical noise issue? I have speedhut gauges and they keep going haywire. Speedhut tech support says it's electrical noise. But they don't have a way to solve the issue.
At first yes. I didn't have an adequate ground from the body to the battery and the engine to the frame. I updated the ground wires and the noise went away. Before I did that my temp gauge would act weird
I just ground through the paint on the cab floor and made a ground strap from the body to the battery and then I made thick ground wire from the battery straight to the engine block and frame
So I figured it out today, I was getting electrical noise from the oil pressure harness because I had the access wire zip tied close to the distributor. I have a sbc and the oil pressure sensor is close to the distributor. So if anyone comes across the same issue I hope this helps.
No, cruise control cannot be run through this. Cruise control will be controlled by a se5perate system on your truck, changing the gauge should not affect it
I know this video is pretty old by now, but did you have the gauges in their dimmest setting? Or is that just how bright they were?
They are much brighter in person. This was filmed with an old go pro and that camera does terrible in low light
@@RecklessWrenchGarage I was hoping so lol I’m designing a set of gauges myself but I can’t find any good footage or photos of that blue it always looks super dim.
How many inch have your speedometer and the tachometer?
Did you have an electrical noise issue? I have speedhut gauges and they keep going haywire. Speedhut tech support says it's electrical noise. But they don't have a way to solve the issue.
At first yes. I didn't have an adequate ground from the body to the battery and the engine to the frame. I updated the ground wires and the noise went away. Before I did that my temp gauge would act weird
@@RecklessWrenchGarage where exactly did you ground the wire too? Mine is currently running under my dash. Should I ground to the battery?
I just ground through the paint on the cab floor and made a ground strap from the body to the battery and then I made thick ground wire from the battery straight to the engine block and frame
Noted, thanks man! Definitely gained a subscriber 👍
So I figured it out today, I was getting electrical noise from the oil pressure harness because I had the access wire zip tied close to the distributor. I have a sbc and the oil pressure sensor is close to the distributor. So if anyone comes across the same issue I hope this helps.
Does it have a way to retain the factory cruise control? Im wanting to use this on my 92 f150
No, cruise control cannot be run through this. Cruise control will be controlled by a se5perate system on your truck, changing the gauge should not affect it
You are your guages pretty dim at night or is that just the video?
It's the video. Blue light at night was very hard for an old go pro to film properly lol
Bang shifting the danger ranger. Lol
Hey! For the gas gauge. Did you change the sender or you kept the oem ?
The ranger is running a fuel cell with a different sender, but the speedhut gauge can accommodate any sensing unit with the push of a button
Is the RPM gauge also GPS??
No just the speedo
How do u edit the fuel gauges on your speedo
There is a button that plugs in to the back of the gauge
Your fuel level gauge looks to be in a different font than the others.
Aaron Lancaster Good eye. The fuel level gauge was purchased at a different time and is slightly different than the rest.
Dude, what was your 1/4 mile time?! :-)
TheBBGlobalNetwork checkout our end of the year video, I answer it there, it was bad though lol
It took off the line well. Had it passed the 1/4mile yet ;)