This bike only has Bank 1 O2 sensor which is installed before Catalytic converter..so no issues...Some bikes have bank 2 o2 sensors which are mounted after cat converter in which case u might need to bypass them...but not in this bike.!!
May i do this for my rc 200bs6 because there is no sound for bs6 if i did this is there any problems about the milage,, power,, water? Kindly reply me bro and is this will help to improve the sound of my bs6? Kindly reply me briefly bro and if i put a hole how i need to close that if i want to close bro?
duke kiddo yes bro i did it for my duke 125 it sounds really awsome it has a good amount of bass aswell like 390 totally worth it just drill 4 holes on the stock exhaust and fit it back and your done :)
usually O2 are always before CAT. There are cars like german cars or most modern cars, that have pre and aft CAT O2 sensors. The aft O2 check the 'health' of the CAT.
Ktm looks ## 🦅 eagle 😄
Ktm performance ## cheetah 💖💖💖💖
Ktm sounds ## auto rickshaw 🔥🔥🔥🔥🔥
sounds good
What i did was just cut off the little pipe and make the hole bigger and it now has a deeper sound and pops alot
Cool sound
RIP stock exhaust
👌🏻 broii....!
Is this will work on my rc 200?
What do you think ?
So that's only Drilling 10mm Holes in stock exhaust of KTM RC 390 to obtain Louder sound and performance..!!
right simplee.....
Bhai iska ek fly by dikhao
Do the holes you've created suck in air? Or does it just expel burning hot air out of them and into bad places?
After doing holes still rc390 gives its signature backfire or not?
Hey, how Do you paint the rear seat? Is ist a spezial paint or something? Thanks for an Antswer...
Will it affect the torque ???
Low end torque , yes but it will not be noticeable while riding.
bro i want know the difference of original and modify sounds
Does the aluminium foil hold without any problems and is there any leakage of air from the joint area?
Not meant for long run..Just temp solution until lead gasket arrived.!!
It's any defect.. Peak power and torque and mileage
Will the sensor still detect it? I'm afraid that it might not get detected and destroy my ecu or other parts of the bike.
This bike only has Bank 1 O2 sensor which is installed before Catalytic converter..so no issues...Some bikes have bank 2 o2 sensors which are mounted after cat converter in which case u might need to bypass them...but not in this bike.!!
@@powerpulse.motorsports is it okay to make holes on exhaust
Will effect the pickup and top speed for ktm rc200??
I'm afraid not..top speed limiter is set to be @ 136kmph for KTM 200..acceleration and mileage can get better slightly. ..
performance will effect ?
Only slight increase in mileage. ..no effect on acceleration or top speed...
how about the fuel??the fuel still save and the pickup or topspeed will not effect??
Bro...... Fully.. Drop pickup 😭😭😭
What can do bro??? 😏😏
@@parvind7019 After doing this Drop in pickup?
May i do this for my rc 200bs6 because there is no sound for bs6 if i did this is there any problems about the milage,, power,, water? Kindly reply me bro and is this will help to improve the sound of my bs6? Kindly reply me briefly bro and if i put a hole how i need to close that if i want to close bro?
Can I try it on NS200?
Any bad effect?
Yes my friend u can...No cons!!
The sound is awesome. But the power is loose. Bosch makes it break. Without software update
Is it bs3 and what's the mileage?
Bro how did you put bigger rear wheels ? What are those size
can I do it with my new duke 125 😁
Sekhar Raja you done for it ?
duke kiddo yes bro i did it for my duke 125 it sounds really awsome it has a good amount of bass aswell like 390 totally worth it just drill 4 holes on the stock exhaust and fit it back and your done :)
Awesome
Nice
Where to drill those holes upside or down the exhaust
need to dyno?
Any mileage change
Plz make the video on road 🙏🙏🙏🥰
How did u put it back on?
Will water get inside through the holes
No,unless u driven through a river
There is a drain hole at the bottom so no problem
so, if the hole is added not only 4 or reduced it will affect the sound?
3 works too , bs6 200 sounds better now after 3 holes . I'm making one more hole and making them bigger also
Bhaiya agar hum RC 200 k muffler ko v isi tarah drill kre tb v kya aise hi sound ayega kya...? Plzz reply
Yess.!!
Hey topend where do i find the holder for injector as its nozzle is broken whenever i switch the key onn the petrol starts falling off in Karizma zmr
Which tyre are you using bro
120/70 & 160/60
Do you know if the O2 sensor is before the catalytic converter in the 2019 RC 390?
usually O2 are always before CAT.
There are cars like german cars or most modern cars, that have pre and aft CAT O2 sensors. The aft O2 check the 'health' of the CAT.
Bro the tool that u have used is great pls tell me the name of it
Can we again make it as normal as before?
why don't u keep a video while riding the Bike
What tyres are you using?
120/70 & 160/60
can i do it on my RS200 bajaj?
Yess.!!
halo bro if we do this exhaust does the police take action
plzz reply
May be..thats upto u how to prevent..!!
Dost puri bike repaint me kitna kharcha aaya?
Plzzzz tell me
Around 7k..Including Paint and Graphics..!!
TopEnd best he sir
Mileage kaam hoyega
Bro it wont effect 200CC engine rite
Not much yeah!
Can you tell me where i can buy stock exhaust for ktm duke200
I have
@@anilpanigrahi6 at what price?
@6000 only
@@anilpanigrahi6 do you meter of bike?
U need the meter set or kms reading
Can i do it for my bike rc200
YESS!!
@@powerpulse.motorsports how many holes are enough
Where do u live bro
Whats e size of e drillbit?
10mm
Bro it's legal
And no need of remap or power comancer
?
😂😂😂 this is rubbish!!!
Why so ?