Tricked worked for me except I had to remove the tube, take the end grommet off and pull enough old cord out to remove this tiny o-ring inside the tube. Then I CA'ed the ends and pulled through the tube like you, then put the old o-ring back on, suck it up into the tube some with the new line and finally put the inside end black cap back on. I used this 2mm line for replacement, works great: Robline - Ocean 3000 Dyneema - 2mm (Grey) - 5/64in
Hello friend, very good video. I have a Vibe kayak and the wiring pod comes out, I thought about putting the plastic tubes from the Hobie in it. Are they glued on the outside or inside the sheath where the cable passes? Thanks a lot!
thanks for the idea! I'M getting ready to replace mine and wasn't sure how i was going to do the!
nice job...i don't have a starter line thru the tube to which to glue it to ...any ideas??
Tricked worked for me except I had to remove the tube, take the end grommet off and pull enough old cord out to remove this tiny o-ring inside the tube. Then I CA'ed the ends and pulled through the tube like you, then put the old o-ring back on, suck it up into the tube some with the new line and finally put the inside end black cap back on. I used this 2mm line for replacement, works great: Robline - Ocean 3000 Dyneema - 2mm (Grey) - 5/64in
Hello friend, very good video. I have a Vibe kayak and the wiring pod comes out, I thought about putting the plastic tubes from the Hobie in it. Are they glued on the outside or inside the sheath where the cable passes? Thanks a lot!
ummm this is really about feeding a new line I wouldn't use it as a install !