Ignition Harness (High Tension) PART 1 - Fabrication - UL350iS - Zenith 750 Cruzer Kitplane Build

Part 1 of fabricating and installing the ignition harness that connects the ignition coils (not magnetos) to the spark plugs in our UL350iS engine (on our Zenith 705 Cruzer). I'm sure I'll get some flak for the non-traditional way I labeled/designated the leads, but that's okay. You set up your engine the way you want. I may end up changing it anyway. Hope this helps!
🛠🧰🛠Tools We Use to Build Our Airplane (that you can get from Amazon)🛠🧰🛠
+ Rivet Gun amzn.to/2oZIpP5
(Be sure to use the custom heads from Zenith for the Zenith rivets!)
+ Gyroscopic Lithium Screwdriver amzn.to/2MnTqBI
+ Swivel Deburring Tool amzn.to/328LRWl
+ Edge Deburring Tool amzn.to/2Iyqy8I
+ 1/4” Drive Torque Wrench amzn.to/2VqcC5L
+ 3/8” Drive Torque Wrench amzn.to/2orWvIR
+ Orange Rubber Tool Tray amzn.to/2VrrlNL
+ Magnetic Parts Holder amzn.to/324M2Sw
+ Dental Picks amzn.to/30WJLax
+ Tap & Die Set amzn.to/2AQRcFE
+ Deburring Wheel for Drill amzn.to/2VqELtJ
+ Fluting Pliers amzn.to/2OvhGV6
+ 1/8” (copper) Clecos amzn.to/2LXrcyz
+ 5/32” (black) Clecos amzn.to/30ZnGYW
+ 3/16” (gold) Clecos amzn.to/2Oyd1lk
+ Right-Angle Drill Attachment amzn.to/30Wp1zy
+ 300mm Metric/Standard Ruler amzn.to/35ec2wt
+ Vise-Grip Pliers amzn.to/2OtQciz
+ Round File amzn.to/32aMvlO
+ Flat File amzn.to/2VvdDJV
(BTW, these are affiliate links. So if you make a purchase using these links, I will make a small commission (but at no extra cost to you 👍))
DISCLAIMER
This video is intended for informational purposes only, and may include information that is inaccurate or not applicable to any other situation. Use any information at your own risk. The individual views and opinions expressed here are solely those of the individual. Always follow manufacturer recommendations and FAA regulations and best practices.
#JeffAndAdamBuildaZenith #builditflyit #zenith750cruzer

[@jaddbo8230]

Great, thanks for cutting out the ONE FUCKING PART I needed to see where you fabricate the ends onto the leads!!!