how about connect in linuxcnc/machinekit? monitor - rasp pi3 - arduino+ether shield - servo/stepper,,then how to connect home,limit,stop etc thank for answer
@UC8XS_ywvHG8eUIFX-RPNMmQ Yes, Your assumption is correct, the Microchip LAN9252 is a "commercial closed chip" that make the EtherCAT protocol and through the SPI Your Microcontroller simply reads and writes the data. In our boards there isn't a firmware. I can give You the schematics if You want and, for more detailed documentations, download the Microchip LAN9252 datasheet from the Microchip website.
if you can send me easycat driver that i have to download to codesys and the step i have to do to wotk easycat with ek1100 beckhoff in ethercat configuration is working very good the easy32 and ek1100 i think i miss something in codesys becuse that wtire the bus not run in ethercat
![Noob To Max With DRAGON REWORK In Blox Fruits [FULL MOVIE]](http://i.ytimg.com/vi/LnBMOinoOvA/mqdefault.jpg)
how about connect in linuxcnc/machinekit?
monitor - rasp pi3 - arduino+ether shield - servo/stepper,,then how to connect home,limit,stop etc
thank for answer
Is this a LAN9252 based device or some other chipset used??
Yes, is the Microchip LAN9252.
@UC8XS_ywvHG8eUIFX-RPNMmQ Yes, Your assumption is correct, the Microchip LAN9252 is a "commercial closed chip" that make the EtherCAT protocol and through the SPI Your Microcontroller simply reads and writes the data. In our boards there isn't a firmware. I can give You the schematics if You want and, for more detailed documentations, download the Microchip LAN9252 datasheet from the Microchip website.
I conect easycat to ek1100 and download to codesys and write bus not run in the codesys if any one can help
if you can send me easycat driver that i have to download to codesys and the step i have to do to wotk easycat with ek1100 beckhoff in ethercat configuration is working very good the easy32 and ek1100 i think i miss something in codesys becuse that wtire the bus not run in ethercat