Beautiful! I use blue painters tape on the clamps before a glue up. I like to use a wet rag to wipe off squeeze out after clamped. Saves me tons of time.
You want the result to be square blanks, for example, the middle blank is 1" and the two extreme blanks are 0.25". Accordingly, the height of all blanks should be (1+.25+.25) 1.5". This should already be the final size
@@Omelchuk.W.O. You might want to invest in some push sticks and blocks. I got nervous everytime you put your fingers near the router bit and saw blade.
Beautiful! I use blue painters tape on the clamps before a glue up. I like to use a wet rag to wipe off squeeze out after clamped. Saves me tons of time.
good ideas, I'll try to remember them next time, thanks
Beautiful Board!!
Nice
Ansome. Could you please provide the dimensions of the individual slats, height, width?
You want the result to be square blanks, for example, the middle blank is 1" and the two extreme blanks are 0.25". Accordingly, the height of all blanks should be (1+.25+.25) 1.5". This should already be the final size
Does DeWalt sponsor you? If not they need to hope on it.
Where's the link to buy this end grain cutting board?
In process
Занурнув в атмосферу відео, тільки приємні враження)
What are the dimensions of the handle?
4" wide by 3/4" high by 1" deep
Che modello è la jointer planner?
The cheapest I found. Something from Craftsman
Some questionable tablesaw habits there. Don't lose your fingers. Beautiful board though. Well done. 👍🏻
yes, you are right, I try not to push my fingers to the blade, but sometimes I forget about it. and thank you
@@Omelchuk.W.O. You might want to invest in some push sticks and blocks. I got nervous everytime you put your fingers near the router bit and saw blade.