How to Setup Minibond Laminator for Double Sided Laminating from Lamination System

A brief video showing how to set up the Minibond A3 Desktop Celloglazer for double sided laminating. This is one of the most common questions we get asked, and a video is much easier to understand than us just trying to explain it!
Some key points:
Machine must be switched to double sided mode PRIOR to turning the machine on. Otherwise the bottom roller won't heat up.
Ensure the film goes BEHIND the bottom idler bar. Check out the web diagram in your Minibond Manual for more info.
You can feed the film up from the bottom, but this can be quite tricky... especially when you have a full roll of film! In this case we recommended feeding the sheet through from the top and attaching to the film.
Once you're set up an running... leave a small gap between the sheets when feeding. This allows you to knife separate the sheets at the rear of the machine, as the perforator only work with single-sided laminating.
As always you can phone us on 1300 099 030 or check out our website for more information www.lamination.com.au