How to Clean BMW 320 d F30 F31 EGR Valve - replacement - Fix Motor Engine pale Light fault problem

Поделиться
HTML-код
  • Опубликовано: 14 янв 2025

Комментарии • 11

  • @jchelm1979
    @jchelm1979 5 лет назад +7

    Bit brutal with the claw hammer there

  • @MASTERSHAK
    @MASTERSHAK  7 лет назад +7

    If this Engine Management light/sign is in Red colour, Stop the car and take it to the Garage because it is serious problem.
    And if this sign is Yellow or Orange colour, then don't worry, You can keep driving, It is not serious issue, It is because any sensor is not responding fully which is a common issue, Not serious. This BMW 3-series F30 F31 model often shows this problem.
    In this case, Just clean the EGR Sensor and it will fix this problem. It is not a major job, You can ask your mechanic to do this or you can clean yourself too as I did in this video.
    Although I couldn't pull out the EGR Valve/Sensor fully but still I was successful to clean some part of it, so my light/sign went away after about 5 miles drive. If you can pull out Valve/sensor fully and clean fully with the brush etc then your light/sign will disappear within minutes.
    ....................................................................................................
    If you like this video, please don't forget to SUBSCRIBE below and give thumb up. Thank you

    • @krzysztofwodzynski2326
      @krzysztofwodzynski2326 7 лет назад +1

      MASTER SHAK
      Z tym młotkiem to lekka przesada, nie polecam tego sposobu można uszkodzić zawór egr lub chłodnice.

  • @brihannavilcalema7426
    @brihannavilcalema7426 2 года назад

    eres un genio hermano desde peru un saludo desde el otro lado del mundooooo

  • @vexx5955
    @vexx5955 11 месяцев назад

    how to remove egr in this case? I HAVE the same problem

    • @jalilahmad1288
      @jalilahmad1288 11 месяцев назад

      Remove the Airbox if you want to completely remove the EGR and give it a thorough clean.
      The EGR is connected with the sensor plug and 2 hoses with pipes connected to it, one visible and other on the other side. Disconnect all 3 and use Oven cleaner and later DW40 Solvent to de-moisturize after clean with any small brush.
      Put it back.

  • @danparaschivoiu8620
    @danparaschivoiu8620 6 лет назад +3

    I use 2 bottles of egr cleaning spray in hose after air filter. Now the check is gone and the car is like new

  • @gaganpreetsingh89
    @gaganpreetsingh89 4 месяца назад

    It’s not completely cleaned unless you take it out and clean it thoroughly.
    The only thing I am bit worried you might have damaged the seat of egr with hammer because at the end it aluminium parts.

    • @MASTERSHAK
      @MASTERSHAK  4 месяца назад

      @gaganpreetsingh89 Hi,
      No, Nothing was damaged. The job was done successfully.
      Some people have the brain and experience to do things with anything including a hammer. This is only a car, not a Space rocket where we need scientists to fix it.
      This video is for people who want to try alternative methods to save money.
      The people who are scared or don't dare to take risks, should go to the mechanic, this video is not for them.
      It is my personal opinion because I fix 90% of my everything from RUclips videos. Thanks to people who post these kinds of videos.
      Hundreds of people messaged me that they had done their job successfully by the help of my video.
      Please view my other video (Short) too, I cleaned the DPF of my 2010 Mercedes C220 TDi by (Fairy washing liquid + Thin Bleach and Tap water). It was done with only £2, instead of paying £150 to the garage to clean my DPF.
      Thank you

  • @akh7508
    @akh7508 5 лет назад +1

    I did this clean the engine light went away but few hours later came on again ? Code is po101 maf sensor?

    • @jeorude33
      @jeorude33 3 года назад

      It’s a Mass flow sensor you might need to clean or replace it.