Hello sir, thanks for the video, and im still learning using ansys. if youre not bussy can u make an analysis "crack in outside pipe due to internal pressure" using ansys please? because i want to learn it so bad. ill really appreciate if you help me, and thanks sir you do the good job for making this video.
Hello Sir, thanks a lot for the video, please, l have a specific problem with [ The None Linear Analysis of Steel/Stainless Steel Concrete Filled Tubes under axial compression ], l have tried several times, but still failed to get the correct data for the analysis, including the deformation, von misses Stress, Strain and all the Deformation curves, so l will really appreciate any help or any possible videos link, once again, thanks a lot for the good job you are doing
Thanks, good to hear you. Then, on what step you're facing this issue. I mean ( Engineering data, geometry or Meshing and final solution ). Because if any material parameters will not in there. It's shown like that. Or In case if you're not choose correct loading point, faces or nodes. It'll be appear.
Hello sir, thanks for the video, and im still learning using ansys. if youre not bussy can u make an analysis "crack in outside pipe due to internal pressure" using ansys please? because i want to learn it so bad.
ill really appreciate if you help me, and thanks sir you do the good job for making this video.
Thanx
Hello Sir, thanks a lot for the video, please, l have a specific problem with [ The None Linear Analysis of Steel/Stainless Steel Concrete Filled Tubes under axial compression ], l have tried several times, but still failed to get the correct data for the analysis, including the deformation, von misses Stress, Strain and all the Deformation curves, so l will really appreciate any help or any possible videos link, once again, thanks a lot for the good job you are doing
Thanks, good to hear you.
Then, on what step you're facing this issue. I mean ( Engineering data, geometry or Meshing and final solution ).
Because if any material parameters will not in there. It's shown like that. Or In case if you're not choose correct loading point, faces or nodes. It'll be appear.
l don't think l have any issues with the ( Engineering data, geometry or Meshing ), but the final solution and that's what i don't understand
Gd
Hi bro, what is the title of this backsound?