On the rear bumper, there is one hole for drilling/riviting that is like directly behind like the running boards wheelie stomp/cross brace. How did you get those in? I left that one out on mine I couldn't get a drill or a rivit anywhere near to go in there.
Solid video man. I stripped one my torx beside the tail light. Can I just cut that brace off or does the grab by use that mounting point? I couldn’t quite tell from your vid Also, could a guy put that front bumper on over polaris skid plate? Thanks in advance!
Looking sweet!!
Get out to Revy young man the snow is deep already
On the rear bumper, there is one hole for drilling/riviting that is like directly behind like the running boards wheelie stomp/cross brace. How did you get those in? I left that one out on mine I couldn't get a drill or a rivit anywhere near to go in there.
Solid video man. I stripped one my torx beside the tail light. Can I just cut that brace off or does the grab by use that mounting point? I couldn’t quite tell from your vid
Also, could a guy put that front bumper on over polaris skid plate?
Thanks in advance!
Ya you should be good you only use rivits on the backwoods bumper so don’t need the bolt could drill it out
How did you get the bottom two bolts in under the sled without removing the pipe? I don't see how to get the nuts down in there..
Nevermind i'm an idiot. realized my hand can fit up in the front of the pipe and reach them.
Привет из России.
Hello 👋
Lets get 10 more pounds of muscle on ya like Caleb
@@semiproish5219 it would take more than ten pounds man