Hello. Thank you for an easy to follow lecture. I however am a bit lost on following the example which is around minute 14 through to minute 18. The example references tables 7 and 5 of the ISO 286 standard, but I don't seem to find the tables. I am using ISO 286-1 2010 and ISO 286-2 2010. May you kindly help me to find the tables in question, or if there is anyone who can help please do. Other than that, the lecture has a gradual introduction of concepts, which makes it easy to understand.
sir when I can control flatness/straightness by angularity, perpendicularity, papalism then why should I use flatness or straightness....please explain these.
thank you so much for this video, and good explaination
Hello. Thank you for an easy to follow lecture. I however am a bit lost on following the example which is around minute 14 through to minute 18. The example references tables 7 and 5 of the ISO 286 standard, but I don't seem to find the tables. I am using ISO 286-1 2010 and ISO 286-2 2010.
May you kindly help me to find the tables in question, or if there is anyone who can help please do.
Other than that, the lecture has a gradual introduction of concepts, which makes it easy to understand.
sir when I can control flatness/straightness by angularity, perpendicularity, papalism then why should I use flatness or straightness....please explain these.
Sir I was your student in BIET Davangere, in which IIT are u employed now
Hello sir tysm for ur lecture.
Sir I need those tables so will u please tell me where to find them.
Sir do u find that table,if u found that pls send me
@@madhusudhanan8962 sure
Hello,
you guys can check this table
www.sharifcadcam.ir/uploaded/3f323a49-f815-4077-b569-73b866c52ada.pdf