Normally the BCS (Bearing Capacity of Soil) is determined by soil investigation on site through boreholes. This value has to be divide FOS = 2 or 2.5 ! Thank You!
What is the ultimate bearing capacity of a circular footing of 1 m diameter resting on the surface of a saturated clay of unconfined compression strength of 100 kN/m2? What is the safe value if the factor of safety is 3?
Excuse me Sir Here this is Local Shear Failure Phi < 26 ° so we have to assume it local shear failure For that Cm = 2/3 × C is to be considered but u have taken here directly C how can it be possible ?? Please reply sir 🙏🙏
For calculating bearing capacity, length of the footing is assumed as 1 meters. It is not calculated. If you're asking about design of the footing, the length comes from loading and flexural requirements.
Thankyou for replying anyways sir....next rime i will practice....tomorrow i will just leave the question if by chance it is asked cuz i cant memorise the bc factors at one night....thanking you sir😘😘😘😘😘😘
Could please NOT mark the calculation with a red marker or erase it after marking that the viewers can take a clean shot of the calls for future reference! Thank you!
Normally the BCS (Bearing Capacity of Soil) is determined by soil investigation on site through boreholes. This value has to be divide FOS = 2 or 2.5 ! Thank You!
What is the ultimate bearing capacity of a circular footing of 1 m diameter resting on the surface of a saturated clay of unconfined compression strength of 100 kN/m2? What is the safe value if the factor of safety is 3?
Please can you tell me how can we calculate bearing capacity using N values (SPT)
sir please tell how calculate depth correction factor asper IS 8009 for SBC asper SPT
Excuse me Sir
Here this is Local Shear Failure
Phi < 26 ° so we have to assume it local shear failure
For that
Cm = 2/3 × C is to be considered but u have taken here directly C how can it be possible ??
Please reply sir 🙏🙏
It was not mentioned in the statement but ur right
haan ye wrong hai
Thanks sir...!! 🙏
Why are you adding gamma x Df and calculating qsafe? Why can’t you just use qns? Thanks
Because in the numerical it was asked to determine q safe not the net safe bearing capacity.
Thank you!
Sir how to calculate Ng?
Once again to tell how to compute the value of length of footing
For calculating bearing capacity, length of the footing is assumed as 1 meters. It is not calculated. If you're asking about design of the footing, the length comes from loading and flexural requirements.
confused how to calculate Area of footing
how to calculate ultimate and allowable load
Divide the SBC with Area of the footing.
Do we need the bc factors or memorise the values?!!
Factors are available along with code. If codes are not allowed in the exam then you will need to remember them.
@@CuriousCivilEngineer but how?? there are so many values....any short trick to memorise it
Sorry no other way. You just have to practice a lot.
Thankyou for replying anyways sir....next rime i will practice....tomorrow i will just leave the question if by chance it is asked cuz i cant memorise the bc factors at one night....thanking you sir😘😘😘😘😘😘
Sure best of luck.
Shubham Bhalchandra Nikumbh B-12
Sir can upload pdf
Could please NOT mark the calculation with a red marker or erase it after marking that the viewers can take a clean shot of the calls for future reference! Thank you!
It is local shear ,,,c should be 13.33 times
Thanks
Your welcome Ruwan
very tanckfull
Pratiksha darade A-27
What ?