I have a 2105 Monster 1200, if I do the install on the kick stand will I need to drain oil?? I just had a full service oil change etc 500km ago, so oil is still mint.
The heat gun took 5-10min to heat it up. You have to move pretty quick to drop it in so have it next to you and ready. To be on the safe side wear some leather gloves! Good luck!
42Nm on the Oil drain plug ? No. The Workshop manual does say 42NM in section 4.3.2 but that is a typo. They later say 20Nm (18min - 22max) , section 3.3.2. 42nm on such a small screw might simply destroy the engine tapping for the screw ... 20Nm lads, NOT 42.
The 659 is for AU only I believe. We don't have them state side. Check with Ducabike directly and I'm sure they can hook you up with the parts you need. Thanks! Here is their website: ducabike.com/ducatiparts/en/
Congratulations on your Clean work! So neat.
Questions. I’ve seen other videos just lean on kickstand and avoid draining oil. Any reason you didn’t do that?
Also what gasket sealer did you use?
I have a 2105 Monster 1200, if I do the install on the kick stand will I need to drain oil?? I just had a full service oil change etc 500km ago, so oil is still mint.
How long did you heat the pressure plate with the hot air gun? How much time do you have to install the bearing before it cools down too far?
The heat gun took 5-10min to heat it up. You have to move pretty quick to drop it in so have it next to you and ready. To be on the safe side wear some leather gloves! Good luck!
How much to install on 2012 Monster 796?
42Nm on the Oil drain plug ? No. The Workshop manual does say 42NM in section 4.3.2 but that is a typo. They later say 20Nm (18min - 22max) , section 3.3.2. 42nm on such a small screw might simply destroy the engine tapping for the screw ... 20Nm lads, NOT 42.
Hows the performace of the ducati clear clutch cover..does it become spongy or hits false neutrals under extreme abuse ,high speeds or long rides
harshwardhan patil no issues yet. It’s been great.
is it normal to have oil inside it , like a washing machine?
Ashish Mishra yes that’s normal.
What type of gasket sealant did you use?
The gasket sealant that was used was Hondabond HT. Thanks!
Where can i find that red Clutch hub.
Andrew Murphy you can get it from Ducabike!
Hi mate ,
Is this suitable for monster 659 ??
The 659 is for AU only I believe. We don't have them state side. Check with Ducabike directly and I'm sure they can hook you up with the parts you need. Thanks! Here is their website: ducabike.com/ducatiparts/en/
where your shop location ?
We are in Los Angeles!
I want but this is so cheap :( and for Panigale not and easy just change the Cover.
I hate that they write ducabike on every damn piece.
Then don't buy them hehe