Just starting to get into the carb system and have just refurbed the Solex carbs on my 1.3 Fulvia coupe. Although helpful if there’s any chance of a more descriptive and instructional video that would be fab !
I haven't tore into this type of carburetor but this video just demonstrates how to balance them using this tool. There are those two screws in the middle. One sets the idle (of both carbs) and the small screw sets the throttle of the forward carb relative to the rear one. I've also used this tool on VW engines so I wanted to make a video demonstrating it. This process probably cannot be done by ear
Hi 5 kg/h at idle it is too high. It should be about 3 /3,5 kg/h at 800-850 rpm. Cylinder number four is poor compared to the others. Adjust the bypass screws to match vacuum between 4 and 3 cylinders. 👌
WARNING: DO NOT REV ENGINE WHILE USING THE TOOL OR YOU'LL BE SHORT 50 BUCKS
Just starting to get into the carb system and have just refurbed the Solex carbs on my 1.3 Fulvia coupe. Although helpful if there’s any chance of a more descriptive and instructional video that would be fab !
I haven't tore into this type of carburetor but this video just demonstrates how to balance them using this tool. There are those two screws in the middle. One sets the idle (of both carbs) and the small screw sets the throttle of the forward carb relative to the rear one. I've also used this tool on VW engines so I wanted to make a video demonstrating it. This process probably cannot be done by ear
Hi 5 kg/h at idle it is too high. It should be about 3 /3,5 kg/h at 800-850 rpm. Cylinder number four is poor compared to the others. Adjust the bypass screws to match vacuum between 4 and 3 cylinders.
👌
What do you call that tool. And where can I buy one
It's a carburetor syncing tool. I bought it on Amazon. Information is in the description of the video.
Thanks