Thank you John for your video could not have done it with out your video and if I did not have your video I think I would have used the F word 100 times. I wish I had some better tools than no rachet and garbage screw drivers. and only just me. Thanks again great video.
I turned it upside and the bottom was on top and easier to hit it with a mallet to get the two sides to lock in place. Then I carefully turned it right side up and was able to slide the sides on to both ends.
Difficult to get the long side panels into the base. Tried the side of my foot like the video and then a hammer and board. No luck so far. hope I didn't get a lemon.
It is good but top cover holes not match its take couple of hours. I got it from Walmart . They just throw all bolt ,nuts and screw to gather. It’s ok product I give **
This is a nightmare to assemble! Wrong lid support sent, had to call and they sent me the correct one. Holes for screws too small, had to go to Home Depot and get a size smaller screw. Still not fully assembled. Not fully assembled yet so I have no idea what other problems we’ll encounter. Also, holes were not pre-drilled!
Thank you John for your video could not have done it with out your video and if I did not have your video I think I would have used the F word 100 times. I wish I had some better tools than no rachet and garbage screw drivers. and only just me. Thanks again great video.
Nice! Is this airtight/bug proof?
Thanks again for your video I purchased 2 more and followed your Pro Video to follow with 100% done. Good job.
Glad it helped!
I turned it upside and the bottom was on top and easier to hit it with a mallet to get the two sides to lock in place. Then I carefully turned it right side up and was able to slide the sides on to both ends.
Difficult to get the long side panels into the base. Tried the side of my foot like the video and then a hammer and board. No luck so far. hope I didn't get a lemon.
So the hammer is for making the pieces fit? The bracket does not line up enough to put the screw in
Front wall of box does not lock into base. How can the wall be modified to fit??
I have the same problem. Followed the video where it was shown as very easy. Not for me. Did anybody solve the panel problem?
What's the best way to bolt it down at the marina
The Dock Box comes with 2 locking brackets that you can slide between the bottom of the wall panels and floor.
It is good but top cover holes not match its take couple of hours. I got it from Walmart . They just throw all bolt ,nuts and screw to gather. It’s ok product I give **
This is a nightmare to assemble! Wrong lid support sent, had to call and they sent me the correct one. Holes for screws too small, had to go to Home Depot and get a size smaller screw. Still not fully assembled. Not fully assembled yet so I have no idea what other problems we’ll encounter. Also, holes were not pre-drilled!