Hello, I followed all your steps and I was able to configure the Kinetix and the servo with no problems. The only problem I'm having is when I unplugged the ethernet cable from the kinetix drive my PLC (L61) goes to Fault Mode, Any suggestions what is happening?
![Motion view on board | [EP.2]](http://i.ytimg.com/vi/VjY4fPTTi4w/mqdefault.jpg)
Great video! We have 24 of these drives. I use this video to remind myself of how to set up.
thanks for your time, l learn so much with this type of video
Useful video thanks. Happened to have the L18 processor and a Kinetix 350 so this was really ideal!
Good video, too bad the video resolution is so poor, that it takes so much quality away from your good work
HOW to setting and programming SLAT function with kinetix 5500 ?
I used the Rslogix 5000 but I might find the kinetix 300. I can upgrade the new version now ?
How is this wired? can you show the wiring in a video?
Hello, I followed all your steps and I was able to configure the Kinetix and the servo with no problems. The only problem I'm having is when I unplugged the ethernet cable from the kinetix drive my PLC (L61) goes to Fault Mode, Any suggestions what is happening?
Prueba esto:
Module Properties (kinetix)...
Pestaña Connection...
Major Fault On Controller if Connection FAils ( no debe estar seleccionado)
how to software ??