Razor E300 Battery Replacement

[@walkweezy31]

Thank you so much for this video. I was struggling with this project with my daughter.

[@EdwardInTX]

How is the ride time on the PowerStar batteries? Are they still good to this day?

[@EdwardInTX]

I ended up going with Casil and Mighty Max for different e300s. Mighty Max runs a bit faster. ruclips.net/video/DRKUKMbNKuk/видео.html

[@hotdon1]

Is there any other way to change the batteries with out having to cut the wires and put on new connectors.

[@okayq]

thank you for sharing

[@SabishiiYasuraka]

Do we really need the wire stripper or we can use basic pliers ? Or can i use 14 gauge female disconnect ?

[@jameskirby5070]

I changed the capacitor to a 63v and when I connect the battery it shot across the room and ride the wall, do you know why its spinning on its own

[@dannyobrian5957]

Will the nine amp damage anything please

[@MinuteMoments]

I haven't had any issues. I'm not an expert but I believe the 9 AH (amp-hours) doesn't change the power the battery gives. It just lasts a longer time. It has greater capacity.

[@kushtyorganz]

What size are the connecters

[@MinuteMoments]

These are what I got: www.homedepot.com/p/Gardner-Bender-1-4-in-Fully-Insulated-Wire-Disconnects-in-Blue-15-Pack-15-153F/202521914?cm_mmc=ecc-
They are 16-14 gauge 0.25" female disconnects

[@titanicbrosgaming8085]

Is there 1 or 2 batteries in the scooter when it comes stock?

[@MinuteMoments]

2

[@jameskirby5070]

When I turn my razor300 on it starts jumping forward over n over again, like its juddering like hiccups. Can you think what's the problem

[@MinuteMoments]

I'd check the throttle cable to see if it's too tight but I must admit a know very little about that

[@jameskirby5070]

@@MinuteMoments ok no problem, thankyou for the reply

[@bexraphaela]

This is where I went wrong.. I thought you should always connect red first and than black, but in the last step you did black first

[@jacobberke2965]

I can’t get the back screws off

[@MinuteMoments]

Are you holding the nut on the underside with a wrench?