2021 Polaris 850 losing power fix

Поделиться
HTML-код
  • Опубликовано: 28 ноя 2024

Комментарии • 32

  • @tumadrewoo249
    @tumadrewoo249 7 месяцев назад +2

    Thanks for the video, i think my 850’s doing the same thing i thought it was the plugs, swapped out the coil boot and nothing. This is my next place to check🔥

  • @rev.dr.davidcole8915
    @rev.dr.davidcole8915 Год назад

    ❤ 'Splained very well. Thank you. Pretty sure you nailed my issue.

  • @markfreywald6478
    @markfreywald6478 2 месяца назад

    My wheeler did it since new, now it does it at start up. Gonna try your trick tonight.. thank you sir!

    • @MrCountryB
      @MrCountryB  2 месяца назад

      @@markfreywald6478 let me know !

    • @markfreywald6478
      @markfreywald6478 2 месяца назад

      @@MrCountryB I have a coil issue I believe. Ran a ground straight to the battery, hit it with water and bogged down. My coil may be cracked.

  • @coryallen4307
    @coryallen4307 2 месяца назад

    It started acting up shortly after I use my four-wheel-drive in some mud, but I didn't see any mud on the coil or anything and it just started raining. I took the plugs out. I cleaned them up. I tightened that screw on the coil, but I still like it's running on one cylinder..

  • @coryallen4307
    @coryallen4307 2 месяца назад

    I just picked up a 2021 sportsman 850. Only 260 miles on it. We went up north on a trip and I bought this so I wouldn't have problems. Turns out mine was the only ones to break down and most of the machines with me were early 2000s it is frustrating.. This quad is in new condition not a speck of dirt or anything. I took it on dirt trails. There was a few small puddles, but nothing serious. I was riding and I felt it surge like it bogged down, then went to full power bogged down again and then it just stayed bogged down over 45 miles an almost like it was on one cylinder. I did clean the contact, put it back on, but it's still doing it. Could it have ruined my plugs arching like this or even ruin the coil? The coil was a little loose and I'm wondering if the arcing could've foul the plugs Or even burned out the coil. It wasn't super loose but loose enough where I could move it around. I sure hope you can help me with this. I'm sick to my stomach all the money. I just spent on it.

  • @mobileenginemedics9679
    @mobileenginemedics9679 5 месяцев назад +1

    My hat is off to you sir. This is definitely a poor design, as it’s only held on by one screw and it screws into a plastic housing. The vibration of the entire coil pack loosens the screw with normal use over time. I had just about given up.

    • @MrCountryB
      @MrCountryB  5 месяцев назад +1

      Did it help you ?

    • @mobileenginemedics9679
      @mobileenginemedics9679 5 месяцев назад

      @@MrCountryB yes my 2021 850 touring was starting and dying. It would run off starting fluid, but wouldn’t stay running on its own, so I was convinced it was a fuel/efi issue. Turns out this was the entire problem. The spark was just strong enough to start the engine but not enough to keep it running once the idle vibration kicked in. I cleaned up the ground and retightened the screw. Problem resolved. (The coil pack was just loose enough where you could feel it wiggle)

    • @MrCountryB
      @MrCountryB  5 месяцев назад +1

      @@mobileenginemedics9679 that’s what his was doing , I put a courser screw in it to have more grip cause that plastic strip easy

    • @mobileenginemedics9679
      @mobileenginemedics9679 5 месяцев назад

      @@MrCountryB it would be much better if they used several screws to mount the coil instead of 1. If mine loosens again I’m going to try to attach the ground to the coil in a more reliable way.

  • @MrTgrasshopper
    @MrTgrasshopper 3 месяца назад

    I have a 2018 sportman 850. It lose all it's power when warm. I'll give this a try.
    What cause the ground to fail when it's warm?
    That ground you are talkijg about. What does it grond?

    • @MrCountryB
      @MrCountryB  3 месяца назад

      @@MrTgrasshopper it grounds the coil pack , it’s a silver backing plate built in it that loses continuity

  • @ProTurbo1988
    @ProTurbo1988 3 месяца назад +1

    I got mine running to the Battery on the Negative side

  • @JoseLopez-k9b
    @JoseLopez-k9b 3 месяца назад

    Did it backfire through intake as well?

  • @JoseLopez-k9b
    @JoseLopez-k9b 3 месяца назад

    Did it backfire through the intake as well bro?

  • @a-ronholscher8529
    @a-ronholscher8529 7 месяцев назад +1

    Has this fixed anyone’s machine ? Mine is starting hard randomly too , my wire is also exposed like his

  • @JohnDavid-gr9rv
    @JohnDavid-gr9rv 6 месяцев назад

    What about single cylinders like a 450 or a 570 Polaris sportsman

  • @grumpyoldman336
    @grumpyoldman336 2 месяца назад

    crazy how my 2010 850 looks pretty much identical to one 12 years newer.. good one polaris for i dunno doing updates lol...

  • @DSGB-4-LIFE
    @DSGB-4-LIFE 9 месяцев назад

    This the case with the sportsman 850 premium or just the HL’s ?

  • @306GokartsCustomBuilds
    @306GokartsCustomBuilds 2 года назад +2

    Would that be a 2011 rzr 800 idles fines but boggs when hitting the throttle. Thanks man

    • @MrCountryB
      @MrCountryB  2 года назад

      You fixed the issue ?

    • @306GokartsCustomBuilds
      @306GokartsCustomBuilds 2 года назад

      @@MrCountryB not yet..in process of rebuilding the fuel pump ..did you know theres two filters on these rzr fuel pump

    • @MrCountryB
      @MrCountryB  2 года назад +1

      @@306GokartsCustomBuilds yes but because it idles fine it should have enough fuel in the rail to at least let you press on the gas for a good 5 seconds before it bogs out of the filters were stopped up

    • @306GokartsCustomBuilds
      @306GokartsCustomBuilds 2 года назад

      @@MrCountryB ok I'll check for good coils ground

  • @TalenHavens-ky5sc
    @TalenHavens-ky5sc 3 месяца назад +1

    My forwheeler i was driving then all this sudden it just got really slow and wont go up to hight rpms

  • @williamwagers3588
    @williamwagers3588 9 месяцев назад

    Did it throw a code on the dashboard, if so what code was it

  • @metlgandalf
    @metlgandalf 8 месяцев назад

    Di is need to unplug the wire in the harness when i put a new wire directly to the frame or can it be installed as it was befor?

    • @jonathansmith7434
      @jonathansmith7434 4 месяца назад

      Should prolli be able to do either way. Boring it directly to metal frame and bolt will just eliminate the same occurrence in the future.

  • @jefferyjackson9559
    @jefferyjackson9559 3 месяца назад

    I need help bad

  • @2ndgensinesterdodge10
    @2ndgensinesterdodge10 2 года назад +1

    That’s a 2022 bro