Thanks for the video. I just unboxed a 150' set of Gen2s and I have open rafters too. I was planning the same thing with the wood. I test cut some wood and plan on taking it a step further. I will be using a 1 1/4 Forstner bit on the back down to 1/8", then a 3/4' hole saw to the front. I would have to use 1x3 strips though. Also a saw blade cut along the back along the middle for a place to slide the wire in between the lights. If it turns out good maybe I could make my first YT video.
Nice! Thank you for sharing your video and how to. Now I know what to add with Govee lights. Gobble Gobble!
Thanks for the video. I just unboxed a 150' set of Gen2s and I have open rafters too. I was planning the same thing with the wood. I test cut some wood and plan on taking it a step further. I will be using a 1 1/4 Forstner bit on the back down to 1/8", then a 3/4' hole saw to the front. I would have to use 1x3 strips though. Also a saw blade cut along the back along the middle for a place to slide the wire in between the lights. If it turns out good maybe I could make my first YT video.
@@ronaldp.2673 Sounds really cool! You should definitely make a video.
Where did u purchase the lights on the garage
@@rcjunkies213 I got them at Sam’s Club (online).