I purchased these pipes to fit my 1995 road king an yes the pipes fit the exhaust ports but be prepared to do cut off the existing bracket mounted to the frame before you install there bracket off the transmission. I’m an old Harley wrench an I’ve had this bike since new so I will inform it wasn’t a quick an easy task. The right side footboard also needed 2 bushings on each bracket not like the video or instructions stated. I had to make 2 bushings. This isn’t a complaint just being informative on a 95 road king a the modification needed.
Video helped me realize the muffler flat bar is missing fom the kit. Also no instructions came with it.Not my first rodeo ,but instructions help keep blood pressure down! Lol
This is taken from the S&S instructions for the sidewinder exhaust. 18.Reuse the stock transmission bracket hardware to install the transmission support bracket. Use the shorter support bracket (#14) for 1995-’06 models and the longer support bracket (#13) for 2007-’16 models. Tighten the bolts to 15-18 lb./ft.. In this video he says the 95-06 bracket is longer and the 07+ bracket is shorter. This is conflicting information. So which is it? Are the instructions correct or is he?
![ROSÉ(로제) - APT. (Band VER.) (With. 이영지) [더 시즌즈-이영지의 레인보우] | KBS 241129 방송](http://i.ytimg.com/vi/IW8qaemx74g/mqdefault.jpg)
I purchased these pipes to fit my 1995 road king an yes the pipes fit the exhaust ports but be prepared to do cut off the existing bracket mounted to the frame before you install there bracket off the transmission. I’m an old Harley wrench an I’ve had this bike since new so I will inform it wasn’t a quick an easy task. The right side footboard also needed 2 bushings on each bracket not like the video or instructions stated. I had to make 2 bushings. This isn’t a complaint just being informative on a 95 road king a the modification needed.
Video helped me realize the muffler flat bar is missing fom the kit. Also no instructions came with it.Not my first rodeo ,but instructions help keep blood pressure down! Lol
Oh dang, there definitely should have been instructions in there.
Neither were there instructions in my kit.
My muffler feels like it's right on the swing arm. Is it going to be that close?
You explained which sensor went into the exhaust but didn't show where the other end goes on the bike.
The rear pipe looks very close to the trans dip stick . How hard is it to check the trans oil?
Plenty of room
This is taken from the S&S instructions for the sidewinder exhaust.
18.Reuse the stock transmission bracket hardware to install the transmission support bracket. Use the shorter support bracket (#14) for 1995-’06 models and the longer support bracket (#13) for 2007-’16 models. Tighten the bolts to 15-18 lb./ft..
In this video he says the 95-06 bracket is longer and the 07+ bracket is shorter. This is conflicting information. So which is it? Are the instructions correct or is he?
The instruction that came with my kit say to use the shorter bracket for 95 to 06 so who’s right the guy on the video or the instructions?
Hey Elias, Todd is correct the longer bracket is for the earlier bikes.
How about a crossover 2 into 2 so there's a muffler on both sides.
We have those as well! Check out the El Dorado system - sscycle.com/
Is it quieter than the thunderheAder? Mines fuckin obnoxious
Absolutely!