Closed Loop Simulation of Buck Converter in MATLAB | SIMULINK

[@raghumaladeshpande1180]

Awesome sir..👍😌

[@ElectronicsMaddy]

Thank you :)

[@Ladakhspa123]

Sir,I have set reference voltage 400 it is coming 383 .where do I need to make some changes?

[@rajinikanth5066]

Can you explain it by using state-space ?

[@hanzalmanzoor2861]

can we generate pulses using sawtooth wave , constant and a comparator ?

[@ElectronicsMaddy]

Constant and saw tooth will give you single pulse modulation output which is highly not recommended. But you can. So the answer is yes

[@manuvincent9793]

Can you show how you got the value of pi controller

[@globalmedya300]

bro how did you calculate R,L,C What is Formula ?

[@ElectronicsMaddy]

Check my video on open loop. There I have given the design

[@HaiderAli-wh9sw]

How we get I=7 in PID controller...
Plz make seprate video .....With proper method to get this value....

[@hpvide]

Close Loop system also used to transfer maximum power from source to load isn't it ??

[@ElectronicsMaddy]

Yes that's one of the scenarios. But in general to establish control over the system.

[@akash1927]

from where do u get I=7? any source or research paper?

[@ElectronicsMaddy]

You need to design based on the requirements. I have made some assumptions and based on that I have found L and C values

[@akash1927]

@@ElectronicsMaddy Actually I am talking about the Integrator Value of the PID controller ..... From where do u got?

[@ElectronicsMaddy]

You have to design it. I have designed using Laplace transform approach

[@HaiderAli-wh9sw]

@@ElectronicsMaddy plz make on video to selection of integer value of PID conctroller