A-4 Skyhawk Remake Flight 4

PLEASE LIKE or SUBSCRIBE!!
DOWNLOAD HERE:
cults3d.com/en...
4th flight of my A-4 Skyhawk. I am playing with the rates and CG! This one is printed using E-Sun with the .48 wall width, using G-Codes found on CULTS3D. For a full description see Cults3D link above.
This is the heaviest version to print. I printed this one with E-Sun Active Foaming LW which has a flow rate which is higher than the other brands to achieve the correct wall width. Also, I printed this one with a .48 wall width, which is thicker than what most people use to print RC Airplanes. I added steel wires throughout the fuselage, across the wing and through the LE of the wing for strength.
G-Codes that are available on Cults3D print very well, but I am still making small changes here and there. If your are going to print this model, please read the instructions that come with the model.
More to come in the near Future. Next version tested will be the COLORFABB .40 Wall Width 50mm version which is the one most people will be interested in, because it will be strong but almost 200g lighter.
This version was to prove that even if you use a thicker wall, and the heaviest foaming LW on the market, you can still HAND-LAUNCH my model! I will continue adding weight until a bungee is required!

[@RDM-RC]

Yea buddy! I am waiting to buy it until I see the 64mm Version! I have 1 64mm EDF that is custom out of an old, crashed plane that would fit great in that, how long till the 64 comes out?

[@William_Holovich]

@@RDM-RC I am hoping by this upcoming weekend!