WCSS DIY: Traction Mat Install on a Yamaha FX

Поделиться
HTML-код
  • Опубликовано: 4 дек 2024

Комментарии • 9

  • @grantsims1729
    @grantsims1729 Год назад

    Great job on the instructions. Thanks

  • @romszy7280
    @romszy7280 6 лет назад +1

    I used hot poddy knife that I rounded the corners with and wash the glue with regular gas . Was using every possible thing but gas worked the best .

  • @kmcelearney
    @kmcelearney 9 лет назад +6

    Goof-off is crap. I used a whole bottle and didn't work at all for me on just one section. Get De-Solv-It Contractors' Solvent.
    After pealing off as much of the mats as you can
    1) Spay on solvent and wait for 5 min or more. I sprayed one section while scraping another
    2) Plastic scrape while wiping scraper with paper towel to get 80% of adhesive
    3) Spray same section again and go to next section that has been soaking
    4) Go back and get remaining 20% use a razor scraper (it will be fine)
    5) Finish spots with a Magic Eraser
    6) Wash off remaining chemicals with plenty of soap (simple green) and water

    • @Ghost.uppercut
      @Ghost.uppercut 3 года назад

      it really is, especially for adhesives, there is too much oil in it. It is better for other types or car badges.

  • @hulk6164
    @hulk6164 2 года назад +1

    Gasoline worked well as an adhesive remover

  • @burtonyeager6817
    @burtonyeager6817 8 лет назад

    what is the pattern called on these traction mats?

  • @baghdadmarine
    @baghdadmarine 4 года назад

    good job thanks for this video +++

  • @kyletrump8025
    @kyletrump8025 2 года назад +1

    Holy Christ man, a little energy? Guy puts me to sleep

  • @zlatkozlatanov790
    @zlatkozlatanov790 4 года назад

    .знам