How to show required hidden lines in NX drafting ?

In this video i have explained how to show required hidden lines in NX drafting.
Intro of nx
• Introduction Of NX 10....
Lect.-1
• How draw a sketch in N...
Lect.-2
• How to make a model wi...
Lect.-3
• All about Edge Blend c...
Lect.-4
• (Continue).... All abo...
Lect.-5
• Pocket & Pad command i...
Lect.-6
• How to apply Emboss & ...
Lect.-7
• Video
Lect.-8
• How to make duplicate ...
Lect.-9
• How to use promote bod...
Lect.-10
• How to use Isolate obj...
Lect.-11
• How to use emboss body...
Lect.-12
• How to use assembly cu...
Lect.-13
• How to use SEW command...
Lect.-14
• How to use Product Int...
Lect.-15
• About PMI & Wave PMI l...
Lect.-16
• how to edit Title Bloc...
Lect.-17
• How to use Patch comma...
Lect.-18
• How to use join face c...
Lect.-19
• How to split a single ...
Lect.-20
• How to use trim & exte...
Lect.-21
• How to make a sheet bo...
Lect.-22
• How to use sheet to so...
Lect.-23
• how to use sweep,varia...
Lect.-24
• How to use move face c...
Lect.-25
• how to use move face c...
Lect.-26
• How to Use Synchronous...
Lect.-27
• How to use Edit cross ...
Lect.-28
• optimize face command ...
Lect.-29
• How to use through cur...
Lect.-30
• Convert sheet into so...
Lect.-31
• Import and Export a mo...

[@mehdipanahandeh6873]

Thank you!

[@Sunilkumaryadav-xx3tt]

thmkyou sir

[@savelbharti6729]

Good

[@Korisidda]

I want do it opposite of what you did... Do you have any video on same...