The cool side heatsink will have steam condensed to water , you need to put bucket below the heat sink and if you want it higher efficiency, use water cooling
I am trying to set up a peltier 12706 supplying power from a 12 Volt, 6 Amp transformer rectifying & filtering it into 12 V DC. At first the heat sinks on the hot side is heating up and cold side is cooling respectively. A few minutes later the cold side is also heating up. How to solve this?
Your cooling solution must be able to dissipate the amount of heat of the peltiers. with 12v 6a thats up to about 72w of heat. You may need to include a water cooling solution to your setup.
Good job... I have a question... 12v x 6amp =72 watt/peltier... Hence total power used roughly around 300w plus 2 fan using around 40watt power =340w....can this 340w peltier ac module cool the room of 150sq ft like air conditioner?
I would love to watch you build one with the hot side heat sinks into a water recipient. Using a device that sends energy pulses instead of a continuous current will make sure the Peltier module doesn't burn down too quickly. You will have warm water for showering and cold air for cooling your room.
Peltier capacity is very low and you can't compare it to proper compressor cooler or wire heater. It can barely warm a bucket of water incase that it is cold weather. Or maybe to cool a room, while barely able to keep cool when you push high pressure fan through the peltier fin. Compressor based air cooler is 10 ~ 20 times more efficient compared to peltier. For example, you need at least 4000 watt of peltier power to cool a room but for the same BTU you can use 400 watt 1/2HP Air con to bring a room to same temperature.
try to connect the wires in series 220 volt, it turns out 18 pieces of Peltier elements, and integrate it all into a long pipe with radiators, one PC fan will blow into the pipe, and on the sides on the Peltier elements there are economical fans on each and they should also be connected in series 18 pieces per 220 volt
попробуй соединить провода последовательно 220 volt это получается 18 штук элементы Пельтье , и это всё интегрировать в трубу длинную с радиаторами , один PC вентилятор будет дуть в трубу, а по бокам на элементах Пельтье на каждом экономичные вентиляторы и они тоже должны подключены последовательно 18 штук на 220 вольт
the Peltier module heats on one side and cools on the other the heated side is not cooled enough the peltier module is inefficient useless so do not use a more energy efficient peltier module
Efficiency is terrible with Peter.. Really just better of with 10 x 250 watt used solar panels that u can steal off someone's roof for free. Some used car batteries, a cheap AliExpress inverter and a 9000 btu inverter type AC. For any real practical use anyway.
Ini efektif..karena panas langsung dibuang keluar ruangan
The cool side heatsink will have steam condensed to water , you need to put bucket below the heat sink and if you want it higher efficiency, use water cooling
Thank you for watching and sharing is very true
@@diyathomevn😂
u mean watrr radiator
@@coolmonkey5269 yes
you made a great project
When you put the Solar Panel to good use I knew immediately you mean business about how Cool you are.
Way too cool ! 🤙That’s what I’m talking about ! You’re a genius . 😉May the cool be with you .🤗❄️💨
It's cool but it doesn't even cost electricity, thank you for watching
ending was very funny😂
u put blanket😂soo cold
It's kind of cool
He was faking it. There was no way to move the heat outside. There was nothing outside.
peltier module working so good 🤔
Rất tốt
up from brazil
Im from Viet nam , thank you
genius
Nhà ông thu mua phế liệu à
nice cool
Thank you for watching, sharing
I am trying to set up a peltier 12706 supplying power from a 12 Volt, 6 Amp transformer rectifying & filtering it into 12 V DC. At first the heat sinks on the hot side is heating up and cold side is cooling respectively. A few minutes later the cold side is also heating up.
How to solve this?
Your cooling solution must be able to dissipate the amount of heat of the peltiers. with 12v 6a thats up to about 72w of heat. You may need to include a water cooling solution to your setup.
10V 10A
thợ điện lạnh xem xong lặng lẽ đi ra lun ,,,
what volts should be used to operate the tec peltier module sir?
the module runs from 10 to 15v, thank you
Wow what brand of soldering iron is that in the video ? Also its a very good video.
The soldering iron in the video was made by me. You can watch the channel for instructions on how to do it
Good job... I have a question... 12v x 6amp =72 watt/peltier... Hence total power used roughly around 300w plus 2 fan using around 40watt power =340w....can this 340w peltier ac module cool the room of 150sq ft like air conditioner?
Thank you, room 9m2 is cool
U mean 9 sqaure meter that is roughly 90sft .. what is the lowest room temperature it gets you?
Genio
Too much work hard... Great project
Please mention Heat Sink size and weight
I would love to watch you build one with the hot side heat sinks into a water recipient. Using a device that sends energy pulses instead of a continuous current will make sure the Peltier module doesn't burn down too quickly. You will have warm water for showering and cold air for cooling your room.
Peltier capacity is very low and you can't compare it to proper compressor cooler or wire heater.
It can barely warm a bucket of water incase that it is cold weather. Or maybe to cool a room, while barely able to keep cool when you push high pressure fan through the peltier fin.
Compressor based air cooler is 10 ~ 20 times more efficient compared to peltier. For example, you need at least 4000 watt of peltier power to cool a room but for the same BTU you can use 400 watt 1/2HP Air con to bring a room to same temperature.
how much Ton bro ???
try to connect the wires in series 220 volt, it turns out 18 pieces of Peltier elements, and integrate it all into a long pipe with radiators, one PC fan will blow into the pipe, and on the sides on the Peltier elements there are economical fans on each and they should also be connected in series 18 pieces per 220 volt
You still need the hidden battery (behind baby diaper bag) to run the Peltier. Solar panel would be enough for the fans, and bit more.
Thank you for watching, for sharing your good comments
lmao 😁😁😁
He is using the diapers for power. They are used diapers.
Buen trabajo. ¿Se puede alimentar el módulo y ventiladores con una batería de auto?
Para operar, debe haber una buena disipación de calor para 2 placas de aluminio separadas 2 cm o más
nice
thank you
very nice? do you plan to put the peltier outside with a water reservoir so the cold water goes into a radiator inside your home?
ok, i cooled it with water, thank you
What peltier module number 🤔
Please close your door with sealing, cooling air leaking in the gap and coming till south india unable to go outside the house.
i think it has not enough insulation and heat spreader, would end up in both side hot then no more heat could be pump
from BANGLADESH .
I'm from Vietnam, thank you
Why u used that 10 watt resistor?
Wow. Your a wizard 🎉pls make a generator from a iPhone charger 👌 in the next video
Sorry but 2 12v peltier unit could not cool a medium sized fridge let alone an entire room.
power supply use server power that only 12V more Amp.
PC電源供應器 還有5V 3.3V分散了 電力，不如使用伺服器的電源供應器 只有12V的 能提供更強的電流。而且二手的不貴。
伺服器的電源供應器 會買二手的人很少 所以不貴。
lol.bro,your peltier super power .😂😂😂
I beg your pardon. The white pieces that have two wires coming out of them, what are they and where can I find them????
Peltier Chip
i already emailed you about this project. i want to know more about it and details for me to rebuild it as my university project
It can be done but the efficiency is not high
@@diyathomevn its okay if its not too efficient, i just want to know the list of the components and materials and how to do it
Anh làm video ngắn gọn lại xong thêm tý nhạc nền nhỏ nhỏ vào thì video sẽ ok hơn
cảm ơn bạn rất nhiều
Never knew pizza hut delivers peltier modules 😅
Bcz you are not updated 😒
I was about to freeze by this Air Conditioner 🥶 Please Power off this 😂
It's only cold in front.😅
Your AC is crying in the corner after watching this
Sher ka bachha ashfaqullah
धन्यवाद
dhanyavaad
Можно было для всей нации хотя бы включить возможность авто перевод , неужели в google не предоставили такую функцию
попробуй соединить провода последовательно 220 volt это получается 18 штук элементы Пельтье , и это всё интегрировать в трубу длинную с радиаторами , один PC вентилятор будет дуть в трубу, а по бокам на элементах Пельтье на каждом экономичные вентиляторы и они тоже должны подключены последовательно 18 штук на 220 вольт
ЕСТЬ ПРИМЕР ЭТОЙ КОНСТРУКЦИИ, КАК ХОТЯ БЫ СХЕМАТИЧЕСКИ ВСЁ ЭТО ВЫГЛЯДИТ ???
@@andredergavin9070 придется создать чертеж и записать видео и скинуть ссылку
@@hronomarti Хотелось бы увидеть эту конструкцию в во всех подробностях.
@@andredergavin9070ruclips.net/video/ciPH44mitEo/видео.htmlsi=cL-_ayxzvKHLbw9r
@@andredergavin9070записал видео извините пожалуйста если там разговор не внятный и если есть какие-то ошибки
Would you please paint your wall 😂
☀❄💨👍👌
Thank you for watching and sharing
the Peltier module heats on one side and cools on the other the heated side is not cooled enough the peltier module is inefficient useless so do not use a more energy efficient peltier module
If you run a large capacity, the heat dissipation is large
make an power amplifier
It's too hot, make the air conditioner temporarily
@@diyathomevn okay
@@diyathomevn ♥️from India
Chinito tenel mucho calol, chinito fabricalce un ailee acondicionado, chinito seguil teniendo calol polque esa cosa no enflia ni madles ...
Este hombre no aguanta ni el calor ni el frio.😂😂😂😂
Gracias, tengo 50 años así que estoy enfermo.
@@diyathomevn Pues para estar enfermo has hecho un buen trabajo, enhorabuena. 🤓👍
Gracias . el ambiente es demasiado caliente
Air conditioner ❌
Peltier ✅
😂😂😂
lol need à very lot of peltier XD buy small air conditionner for that price XD
FULLY RESTORATION SOLUTION How are you??
Me second
Thank you for watching and sharing
Make it in English
😂😂😂😂😁😁😁😁
u guy have no sun 😁😁
those things are terribly inefficient compared to a heat pump. after a year of use you would end up paying more than a heat pump costs just in power.
Efficiency is terrible with Peter.. Really just better of with 10 x 250 watt used solar panels that u can steal off someone's roof for free. Some used car batteries, a cheap AliExpress inverter and a 9000 btu inverter type AC. For any real practical use anyway.
Doesn't work
Thank you for watching and sharing, you should try it, don't do it for real
I know how to speak Vietnamese..ping bong ping bong bong bong mia bong
Oh great, I'm Vietnamese
😂😂😂😂
😂😂😂😂
@@lolwthy it's the 'BONG' init..haha
Можно было для всей нации хотя бы включить возможность авто перевод , неужели в google не предоставили такую функцию
Oh men 😂😂😂😂😂😂😂😂😂
It will cool your face only 😂
English?
that's not worth it
Dont waste your money in peltire module. its life is only 1 week i tried three modules with proper power supply.
Buy AC instead.😅
Are you sure? That's very short life
@@debasishrath7943buy a proper heat pump if you want to cool a room. The easiest way to get it is by buying an air conditioner.
Oh man, his Vietnamese is so hard to understand lol.
this ignorant definitely dont understand TEC technology and its efficiency. sad he put effort use blanket for gimmick.
Really, man
@@diyathomevn dont mind my comment dude, just keep doin what are you doin and keep the blanket clean. have a nice day. more power.
Fake😂
what a dumb idea
I am first commenter😂
Thank you for watching and sharing