2019-2020 Dynamic Sauna Assembly Video
HTML-код
- Опубликовано: 15 окт 2024
- 2019-2020 Dynamic Sauna Assembly Video
(DYN-6106-01 Barcelona DYN-6202-03 Versailles DYN-6206-01 San Marino)
(DYN-6210-01 Venice DYN-6220-01 Vittoria DYN-6215-01 Vienna)
(DYN-6310-01 Madrid DYN-6330-01 Palermo DYN-6306-01 Bellagio DYN-6336-01 Lugano DYN-6315-01 Florence)
(DYN-6410-01 Grand Madrid DYN-6440-01 Bergamo)
Great video. Just what you need to know and nothing more. Took my son and I about an hour and a half from start to finish. No complaints!
Instructions don't show the particle board roof barrier orientation that goes overthe wires and power supply. Also, had to use a rubber mallot to move the bottom of the panels over to get them to line up properly. Along with that there seem to be a lot more screws than what is required.
How do you assemble tge back panel last when sauna is placed against a wall. With 2 people can you change the order of assembly
STEP ONE TO TWELVE
STEP ONE
Start by placing the sauna’s floor panel on a dry and level surface. The floor heater cord could be located at what’s will be the left rear side of the sauna room.
STEP TWO
Carefully life the front wall panel up and onto the sauna’s floor panel. Be sure that the front wall panel is centered on the sauna’s floor panel.
STEP THREE
Hold the front wall panel in place while a second adult lifts the right side wa;; panel up and on the saunas floor panel.
STEP FOUR
The guide and guide inserts will need to be positioned so that the right side wall is lifted and inserted into the front wall panel.
STEP FIVE
Once inserted, the right side wall will need to slide downward until the two wall panels are flush at the top. The same will need to be done for the left side wall panel.
STEP SIX
To install the rear wall panel, open the side wall panels a little to allow for the rear wall panel to be installed. Two adults will need to life the rear wall panel up and onto the sauna’s floor panel.
STEP SEVEN
Fasten the buckle to the wall. Be careful as the heater cords and wiring harness will need to be fed through the holes in the roof panel.
STEP EIGHT
Install the roof panel. Two adults will need to life the roof panel and onto the sauna room. Be careful as the heater cords and wiring harness will need to be fed through the holes in the roof panel.
STEP NINE
The bench heater panel will need to be installed next. When installing, the bench heater panel will need to be inserted at an angle and then slid down into place. Be sure to connect the floor heater cord and the bench heater cord into the applicable outlets underneath the bench. Next, the bench can be placed over the bench heater panel and slid back into place. The bench can be secured using the two provided wood screws.
STEP TEN
You will need a step ladder to go up to the roof top and make the heater cords and harness connections. The heater cords and wiring harness will need to be connected with their counterparts up on the roof panel.
STEP ELEVEN
The black protection corners around the glass edges will need to be removed and discarded. To install the door handle, you will need a Philips screwdriver. You will first separate the door handle noting the order of the pieces. The rubber gaskets will be used so that the metal pieces of the door handle do not touch the glass. Be sure not to over tighten the screws ( Watch 3:20 seconds to see how handles are connected - ruclips.net/video/jOoHTGN5cWk/видео.html )
STEP TWELVE
Operate the power Botton.
Up and down arrow to temp display ( ruclips.net/video/jOoHTGN5cWk/видео.html).
Adjust the time by pressing up and down arrow (ruclips.net/video/jOoHTGN5cWk/видео.html ).
Im
😊n
Where does the LED bench light connect to ? I can't find any outlet for it, thanks in advance!
same problem
inserting the third panel is nowhere as easy , and the video doesn't show it. Furthermore, this video and the manual are old and do not match what was received. Sloppy.
I wanted to know the electrical plug was on the unit, I would still like to know.
yes, I'm also trying to find out where the cord is and how long it is... I need to put it in a snug spot but need to know where to put the outlet (hoping to put it above the unit)
On my unit, it comes out from the ceiling and drops down the back. It's probably 8' long or something, so it has some reach to an outlet directly behind or near the sides of the unit.
Is this sauna for the outdoor or indoor?
Indoor use only
Love it!
Do I need to add a foil moisture wrap/barrier to insulate the unit?
No.
What's the emf rating like for this?
EMF between 6-10MG - 6 to 8 inches from the heating panels
Helped when we put it together
What are the dimensions of the front and rear panels?
Please contact Steffen at our office at 909-212-5555 or email at info@goldendesignsinc.com. Steffen will help assist. thank you!
I'll bet they workout