Configuring vSwitch or vNetwork Distributed Switch from the command line in ESXi/ESX KB1008127

Learn how to configure vSwitch or vNetwork Distributed Switch from the command line in ESXi/ESX. This comprehensive guide provides step-by-step instructions to restore management network connectivity via the correct vmnic interface. Discover essential commands and best practices to effectively manage your network setup.
kb.vmware.com/s/article/1008127

[@vmwarekb]

If you found this video helpful, don't forget to give it a thumbs up and subscribe to our channel for more informative content. Have suggestions for other KB vides? Comment below!

[@mtn_gngr]

I was expecting to see next commands and how to use them, remove with Q and add with P Can you also share those steps in a video capture?
Add or remove network cards (known as vmnics) to or from a vNetwork Distributed Switch (vDS) using these commands:
esxcfg-vswitch -Q vmnic -V dvPort_ID_of_vmnic dvSwitch # unlink/remove a vDS uplink
esxcfg-vswitch -P vmnic -V unused_dvPort_ID dvSwitch # add a vDS uplink
From the esxcfg-vswitch -l command output, how exactly the command is used?