REVIT Railing and Posts Tips - CADclips

Поделиться
HTML-код
  • Опубликовано: 1 янв 2025

Комментарии • 10

  • @jmgranat
    @jmgranat 3 года назад

    Very helpful thank you so much.

  • @onetwoby4
    @onetwoby4 9 лет назад

    It helped me a lot!
    Thanks Daryl.

  • @73jaleel
    @73jaleel 11 лет назад

    thanks---- very useful

    • @LearnREVITfast
      @LearnREVITfast  9 лет назад

      +Abduljaleel Bappathi Thanks, you are welcome !

  • @monieamara
    @monieamara 7 лет назад

    THANK YOU FOR THE TUTORIAL. EVERY STUDY TEACHERS HOW TO USE A SINGLE LANDING BUT NOT A DOUBLE LANDING. ig. Stairs from ground floor to upper floor. Runs coming up ends half way in the 1st landing width & height of the run but depth of say 900mm. From there it goes into 2nd landing higher than the 1st with same width, height & depth, and runs turns , goes parallel to the runs from ground floor up to the upper floor.
    Normally two runs joins with one landing in the middle but not with two parts. 2 x Half a landing.
    I have searched for stairs by sketch yet couldn't find it. Please help.

    • @LearnREVITfast
      @LearnREVITfast  7 лет назад

      Makes sense to me but as you describe would involve more than one stair. The new REVIT multi stair however may be your answer.

    • @monieamara
      @monieamara 7 лет назад

      Thank you for replying, New Multi stairs shows none. It is an old fashion staircase bit like the winder but cannot see a tutorial for it.

    • @monieamara
      @monieamara 7 лет назад +1

      Thank you. I am trying to draw by sketch if possible.

  • @eng.mohamednagaty977
    @eng.mohamednagaty977 8 лет назад

    ؟good But possible translation into Arabic